Questiona machine part consists of a thin 400 cm long bar, Ask an Expert

Academics

Question

A machine part consists of a thin 40.0 cm long bar with small 1.15 kg masses fastened by screws to its ends. The screws can carry a maximum force of 75.0 N without pulling out. This bar rotates about axis perpendicular to it at its center.

A) As bar is turning at a constant rate on a horizontal, frictionless surface, what is utmost speed the masses can have without pulling out screws?

B) Presume machine is redesigned so that the bar turns at a constant rate in a vertical circle. Will one of screws be more likely to pull out when the mass is at the top of the circle or at bottom? Utilize a free-body diagram to see the reason.

C) Using result of part B, what is maximum speed the masses can have without pulling a screw?

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9719473

Have any Question?Write your Review or question?

Related Questions in Physics

Question at one point in a pipeline the waters speed is 300

Question: At one point in a pipeline the water's speed is 3.00 m/s and the gauge pressure is 5.00 x 10 4 Pa. Find the gauge pressure at a second point in the line, 11.0 m lower than the first, if the pipe diameter at the ...

Problem here we ponder a few issues related to

Problem: Here we ponder a few issues related to thermodynamic reversihilityfirrerversihility. Recall that a process is said to be thermodynamically reversible if and only if there exists an e?ecing process. That can retu ...

Qestion a spring of negligible mass has force constant k

Question: A spring of negligible mass has force constant k = 1500N/m . Part (a): How far must the spring be compressed for an amount 3.40J of potential energy to be stored in it Part(b): You place the spring vertically w ...

An object traveling with a speed of 377 suddenly

An object traveling with a speed of 37.7 suddenly experiences a constant acceleration of 7.71 m/s 2 . What distance does this object travel in 6.48 seconds?

Question a soap bubble is essentially a thin film of water

Question: A soap bubble is essentially a thin film of water surrounded by air. The colors you see in soap bubbles are produced by interference. What visible wavelengths of light are strongly reflected from a 390 nm -thic ...

Question suppose that there are two goods available to the

Question: Suppose that there are two goods available to the consumer-pens and pencils. Suppose that the price of a pen is $2.00 while the price of a pencil is $0.50. If we measure the quantity of pens on the horizontal a ...

Question a small particle has charge -200 uc and mass

Question: A small particle has charge -2.00 uC and mass 1.50Ã-10-4 kg. It moves from point A, where the electric potential is V(A) = 200 V, to point B, where the electric potential V(B) = 920 V is greater than the potent ...

Question part a find the energy u0 stored in the capacitor

Question: Part A: Find the energy U0 stored in the capacitor. Express your answer in terms of A, d, V, and Ïµ0. Remember to enter Ïµ0 as epsilon_0. Part B: The capacitor is now disconnected from the battery, and the plat ...

Question a person takes a trip driving with a constant

Question: A person takes a trip, driving with a constant speed of 89.5 km/h, except for a 22 minute rest stop. If the persons average speed is 77.8 km/h how much time is spent on the trip and what distance did they trave ...

Question youre driving down the highway late one night at

Question: You're driving down the highway late one night at 20m/s when a deer steps onto the road 35m in front of you. Your reaction time before stepping on the brakes is 0.50s, and the maximum deceleration of your car i ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert