Question the dynamic response of t6nbspin the heat, Ask an Expert

Academics

Question: The dynamic response of T₆ in the heat exchanger and stirred-tank system in Figure Q5.9 is to be determined for a step increase in the flow to the exchanger F_ex, with the total coolant flow Fc constant. (Assume that negligible transportation lag occurs in the pipes.)

(a) Derive the models for both stirred tanks.

(b) Determine the individual transfer functions.

(d) Which of the general system structures covered in this chapter de scribes this system?

(e) Explain the numerator zeros (if any) and poles in the system.

(f) Describe the dynamic response of this system for the input step change in F_ex.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M92584763

Have any Question?Write your Review or question?

Related Questions in Chemistry

What would an increase in the metal wire mass indicate when

What would an increase in the metal wire mass indicate when the metal wire starts to form copper on it from a chemical reaction from 6M HCl and copper (II) sulfate pentahydrate? What would a decrease in the metal wire ma ...

The earth receives approximately 2 x 1014 kjs of solar

The Earth receives approximately 2 x 1014 kJ/s of solar energy. What mass of solar material is converted into energy each second to produce this much energy

The molecular weight of an unknown gas was measured by an

The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?

The mass of a sample of caco3 is 751 grams how many total

The mass of a sample of CaCO3 is 751 grams How many total atoms are present in this sample?

Aqueous lithium sulfate was mixed with aqueous strontium

Aqueous lithium sulfate was mixed with aqueous strontium chlorate, and a crystallized strontium sulfate product was formed. Consider the other product and its phase, and then write the balanced molecular equation for t ...

Asolution is prepared by dissolving 2244 grams of acetic

Asolution is prepared by dissolving 22.44 grams of acetic acid inenough water to make250.0 mL of solution. A 25.00-mL aliquot of NaOH solution is thentitrated with the acetic acid solution. 37.28 mL of the acetic acid so ...

Assume that you dissolve 102 g of a mixture of naoh and

Assume that you dissolve 10.2 g of a mixture of NaOH and Ba(OH)2 in 227.0 mL of water and titrate with 1.47M hydrochloric acid. The titration is complete when 107.8 mL of the acid has been added. What is the mass (in gra ...

At a given pressure and temperature it takes 1987 sec for a

At a given pressure and temperature, it takes 198.7 sec for a 2.6 L sample of Kr to effuse through a porous membrane. How long does it take for 2.6 L Ar to effuse under the same conditions?

A 0235g sample of a solid is 925 naoh and 75 caoh2 by mass

A 0.235g sample of a solid is 92.5% NaOH and 7.5% Ca(OH)2, by mass requires 45.6mL of a HCl solution for its titration. What is HCl molarity?

It takes 378 ml of 02114 m naoh to neutralize 193 ml of an

It takes 37.8 mL of 0.2114 M NaOH to neutralize 19.3 mL of an oxalic acid solution with an unknown concentration. Calculate the actual concentration of this oxalic acid solution. Don't forget to look at the balanced equa ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert