Question- suppose a thickener in a metal plating plant, Ask an Expert

Academics

Question- Suppose a thickener in a metal plating plant receives a feed of 40 m3/hr of precipitated metal plating waste with a suspended solids concentration of 5000 mg/L. If the thickener is operated in a steady state mode so that 30 m3/hr of flow exits as the overflow, and this overflow has a solids concentration of 25 mg/L, what is the underflow solids concentration, and what is the recovery of the solids in the underflow?

Show all steps to describe the solution of above problem

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91240047

Have any Question?Write your Review or question?

Related Questions in Chemistry

Silver nitrate has the molecular formula agno3 in a 1090 g

Silver nitrate has the molecular formula AgNO3. In a 109.0 g sample of silver nitrate, how much of that mass (in g) is from the silver atoms?

2k3po4aq3mgcl2aq rarr mg3po42s6kclaqthe molecular equation

2K3PO4(aq)+3MgCl2(aq) → Mg3(PO4)2(s)+6KCl(aq) The molecular equation you determined in Part B is shown above for your convenience. Examine each of the chemical species involved to determine the ions that would be present ...

Do you notice any trends or can you make any

Do you notice any trends or can you make any generalizations about where certain types of liquids fall on the pH scale?

A sealed vessel contains a gaseous mixture of h2 and excess

A sealed vessel contains a gaseous mixture of H2 and excess O2. The mixture is at 500 K and has a total pressure of 140 kPa. After all of the hydrogen is reacted, the total pressure of the system measured at the same tem ...

What are transition metals and what specifically happens to

What are Transition Metals and what specifically happens to transition metals that results in solutions that give off distinct colors?

Ttrate the base trimethylamine tma with 0126 m hcl ch3naq

Titrate the base trimethylamine (TMA) with 0.126 M HCl. (CH) 3 N(aq) + H 2 O(l) (CH 3 ) 3 NH+(aq) + OH-(aq) Kb = 6.45 x 10 -5 There are 0.00615 moles of TMA in 42.5 mL H 2 O before titration begins. What percent of TMA i ...

A sample of cobalt ii chloride hydrate starts with a mass

A sample of cobalt (II) chloride hydrate starts with a mass of 3.35 g. After heating, the sample mass is 1.83 g. What is the molar ratio of water to cobalt chloride? What is the correct chemical formula

Does dissolved solids such as sugar and salt modifychange

Does dissolved solids such as sugar and salt modify/change the boiling point of water; do mixtures have the same boiling point as pure substances?

Question 1bonding energyi draw an energy level diagram for

Question 1: Bonding Energy i. Draw an energy level diagram for a single Na ion and Cl ion. ii. Explain what is happening to the energy level between these two ions in terms of the Potential Energy. iii. Which process uti ...

What mass of solid naoh 970 naoh by mass is required to

What mass of solid NaOH (97.0% NaOH by mass) is required to prepare 1.00 L of a 10.0% solution of NaOH by mass? The density of the 10.0% solution is 1.109 g/mL.

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert