Question- a blank is typically chosen to represent a zero, Ask an Expert

Academics

Question- A blank is typically chosen to represent a zero or bseline absorbance reading. the blank itself does not need to have a zero absorbance reading before calibration, and this trait is often used to remove impurities and any stray signals that would otherwise interfere with your reading. With this in mind, defend the composition of the blank that you used.

Please illustrate work and walk me during the problem so that I can follow and understand it.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91250684

Have any Question?Write your Review or question?

Related Questions in Chemistry

A sealed vessel contains a gaseous mixture of h2 and excess

A sealed vessel contains a gaseous mixture of H2 and excess O2. The mixture is at 500 K and has a total pressure of 140 kPa. After all of the hydrogen is reacted, the total pressure of the system measured at the same tem ...

Cesium-137 has a half-life of 3017 years the first atomic

Cesium-137 has a half-life of 30.17 years. The first atomic explosion at Trinity Site in New Mexico in 1945 generated significant amounts of cesium-137. It has been 73 years since this detonation. What fraction of the ce ...

What is the subshell electron configuration for the ca20

What is the subshell electron configuration for the Ca20 atom? Which are valence electrons and how many valence electrons are there?

Calculate the number of moles of barium chloride in 427g of

Calculate the number of moles of barium chloride in 427g of a 3.17% by mass barium chloride solution?

As your book describes the united states did not recognize

As your book describes, the United States did not recognize foreign copyrights until the late 1800s. As a result, U.S. publishers routinely published foreign works without permission or compensation for the non U.S. auth ...

100 mole of sodium carbonate formula mass 1060 is converted

1.00 mole of sodium carbonate (formula mass 106.0) is converted to sodium chloride, Na2CO3(s) + 2HCl(aq)® 2NaCl(aq) + H2O +CO2(g). The percentage yield in this conversion is 80%.Which of the following is correct: a. 0.80 ...

How many moles are in 8552e02 mg megagrams of nickel iii

How many moles are in 8.552e+02 Mg (megagrams) of Nickel (III) sulfate? How many molecules are in 5.048e+02 g (grams) of Ammonium Thiosulfate? How many grams do 3.270e+20 molecules of Manganese (IV) phosphate weigh

If 0050 mol hydrochloric acid hcl is mixed with 0050 mol of

If 0.050 mol hydrochloric acid (HCl) is mixed with 0.050 mol of sodium hydroxide (NaOH) in a "coffee cup" calorimeter, calculate the temperature change of 34.6 g of the resulting solution if the specific heat of the solu ...

What could a source of error be during a titration lab that

What could a source of error be during a titration lab that is not a humans fault?

How is vacuum filtration completing the purification of

How is vacuum filtration completing the purification of your sample? Where are the impurities at this point? For a recrystallization lab in organic chemistry

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert