Problem tightening a spark plug requires a 40nm torque if, Ask an Expert

Academics

Problem: Tightening a spark plug requires a 40Nm torque. If you pull a 16cm wrench at a 700 angle (to the wrench),

Part A: At what force must you pull to achieve a 40Nm torque?

I want help to find at what force you must pull to achieve a 40Nm torque.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91256788

Have any Question?Write your Review or question?

Related Questions in Physics

Question a softball pitcher throws an underhanded pitch

Question: A softball pitcher throws an underhanded pitch with the arm fully extended (straight at the elbow). The ball leaves the pitcher's hand with a speed of 25 m/s. Assume that the pitching motion originates with the ...

Question suppose you have a fixed charge of -150 nc at

Question: Suppose you have a fixed charge of -15.0 nC at point X. Points A and B are to the right of point X at distances of 20.0 cm and 40.0 cm from X respectively. Calculate the following: a) the potential at points A ...

Question a pendulum has a period of 177 s on earthpart a

Question: A pendulum has a period of 1.77 s on Earth. Part A: What is its period on Mars, where the acceleration of gravity is about 0.37 that on Earth? Express your answer to two significant figures and include the appr ...

Suppose the convention were adopted that defines w and w 0

Suppose the convention were adopted that defines W and W 0 in the first law of thermodynamics to be the "work done on the system by the surroundings." a. Write the first law with this alternate convention. b. Why do the ...

What is the average acceleration of a vehicle which speeds

What is the (average) acceleration of a vehicle which speeds up from 22 m/s to 88 m/s in 21.2 seconds? please provide work to explain

Question the otto-cycle engine in a mercedes-benz slk230

Question: The Otto-cycle engine in a Mercedes-Benz SLK230 has a compression ratio of 8.8. A. What is the ideal efficiency of the engine? Use Î³=1.40. Express your answer using two significant figures. B. The engine in a ...

A ball with a mass of 15 kg is observed to move with an

A ball with a mass of 1.5 kg is observed to move with an acceleration of 6 m/s2. What is the size of the net force acting on the ball? A 2.5-kg block being pulled across a table by a horizontal force of 80 N also experie ...

Question a standard biological microscope is required to

Question: A standard biological microscope is required to have a magnification of 200Ã-. When paired with a 10Ã- eyepiece, what power objective is needed to get this magnification? Part A: Assume that the length of the t ...

Question as shown in the figure there are 3 point charges

Question: As Shown in the figure, there are 3 point charges along the x-axis located at 3,8, and 11 cm. What is the x-component of the force on the charge located at x = 8 cm given that q = .85 uC in N? The response must ...

Question a solid disk of mass m1 96 kg and radius r 024 m

Question: A solid disk of mass m1 = 9.6 kg and radius R = 0.24 m is rotating with a constant angular velocity of ? = 30 rad/s. A thin rectangular rod with mass m2 = 3.4 kg and length L = 2R = 0.48 m begins at rest above ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert