Problem- what is the advective flux of total cr that is, Ask an Expert

Academics

Problem- What is the advective flux of total Cr that is discharged into a river (assume no Cr in the river before the discharge) with a flow rate of 15 m3/s from two leather tanning facilities? The first facility discharges 100 L/s of wastewater contaminated with 1 mg Cr/L, while the second one discharges at a rate of 50 L/s and a concentration of 15 mgCr/L. Consider the cross-sectional area of the river is 20 m2 after all discharges. Calculate the flux at point characterized by the cross-sectional area.

State your answer by means of two significant figures.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91257382

Have any Question?Write your Review or question?

Related Questions in Chemistry

The earth receives approximately 2 x 1014 kjs of solar

The Earth receives approximately 2 x 1014 kJ/s of solar energy. What mass of solar material is converted into energy each second to produce this much energy

A paint contains 1800 ppm lead approximately what mass of

A paint contains 180.0 ppm lead. Approximately what mass of lead will be in 1.00 cm ^3 of this paint when 1.00 gal is uniformly applied to 445.0 ft 2 of a wall. The density of the paint is 8.00 lb/gal.

While heating your copper sulfur mixture the original

While heating your copper sulfur mixture the original crucible lid fell and was broken. You replace the lid with another one. You used the mass of the original lid in your calculations. However the mass of the second lid ...

An electron is ejected from a metal with a velocity 778

An electron is ejected from a metal with a velocity 7.78 x10^5 m/s. If the metal has a threshold frequency of 9.90 x1014 Hz, what was the wavelength of the incident photon?

At rest a person inhales 9721021 nitrogen molecules in an

At rest, a person inhales 9.72*10^21 nitrogen molecules in an average breath of air. How many mole of nitrogen atoms are inhaled? (Hint: in air, nitrogen occurs as a diatomic molecule)

What is the minimum amount of 60 m h2so4nbspnecessary to

What is the minimum amount of 6.0 M H 2 SO 4 necessary to produce 25.0g of H 2 (g) according to the reaction between aluminum and sulfuric acid? 2 Al(s) + 3 H 2 SO 4 (aq) --------> Al 2 (SO 4 ) 3 (aq) + 3 H 2 (g)

What will happen if i decide to test the solubility of

What will happen if I decide to test the solubility of sodium chloride in ethanol which is less polar than water.

A chemist addsnbsp750 ml of anbsp192mnbspnickelii

A chemist adds 75.0 mL of a 1.92 M nickel(II) chloride (NiCl2) solution to a reaction flask. Calculate the millimoles of nickel(II) chloride the chemist has added to the flask. Round your answer to 3 significant digits.

How many formula units of barium fluoride baf2 are in 163g

How many formula units of barium fluoride (BaF2) are in 1.63g of BaF2 How many formula units of aluminum chloride (AlCl3) are in 0.582g of AlCl3 How many grams of caffeine (C8H10N4O2) contain 2.53×10^24 molecules of caff ...

Give an example of when heat is released from water as it

Give an example of when heat is released from water as it undergoes a change of phase.

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert