Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

The mixing process might be describeed as follows: a stream with solute concentration Ci (pounds/volume) is fed to the perfectly stirred tank at a constant flow rate of q (volume/time). The perfectly mixed product is withdrawn from the tank, as well at the flow rate q at the similar concentration as the material in the tank, C. The total volume of solution in tank is constant at V. Density might be considered to be independent of the concentration.

A trace of the tank concentration versus the time appears as shown in the figure below:

1545_tank concentration versus time.jpg

Q1. Plot on this similar figure your best guess of the quantitative behavior of the inlet concentration versus the time. Be sure to label the graph with quantitative information concerning times and magnitudes and any other data which will describe your understanding of the condition.

Q2. prepare down an equation for Ci as a function of the time.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M99662

Have any Question? 


Related Questions in Physics

1 is the drift current formulae an equilibrium or

1. Is the drift current formulae an equilibrium or nonequilibrium expression? 2. A current of 1 A/cm 2  is forced through an n-type Si bar with a resistivity of 1 ohm-cm at 300K. What is the drift velocity of the electro ...

How can you use a coin to create a random ranking of 3

How can you use a coin to create a random ranking of 3 people? Construct a solution that uses exact sampling. For example, you could apply exact sampling to a Markov chain in which the coin is repeatedly used alternately ...

A rubber is subjected to a shear stress such that lambdaxl

A rubber is subjected to a shear stress such that λx=l, λy=1. Obtain an expression relating the shear stress, and the shear strain, assuming shear strain=λ-1/λ. Comment on the difference between this stress/strain relati ...

1 when the reflected waves meet they interfere with each

1. When the reflected waves meet they interfere with each other. Can you see points of constructive and destructive interference? Describe them. 2. What is the location of the virtual source (also known in optics as the  ...

Fatty deposits in blood vessels pose a health risk chemical

Fatty deposits in blood vessels pose a health risk. Chemical agents added to the blood can increase the solubility of the fatty deposits in blood, thereby providing a means to dissolve the fatty deposits in situ. To expl ...

1 when a cars engine makes less than about 200 revolutions

1. When a car's engine makes less than about 200 revolutions per minute, it stalls. What is the period of the rotation of the engine when it is about to stall? 2. What is the period of the earth's revolution around the s ...

Discussion 1 -once you learn the names of the major logical

Discussion 1 - Once you learn the names of the major logical fallacies, you will probably start noticing them all over the place, including in advertisements, movies, TV shows, and everyday conversations. This can be bot ...

An 1800 kg car stopped at a traffic light is struck from

An 1800 kg car stopped at a traffic light is struck from the real by a 900kg car. The two cars become entangled, moving along the same paths that of the originally moving car. If the smallest car were moving at 20m/s bef ...

First generation 1960 ultrahigh speed switching si diodes

First generation (1960) ultrahigh speed switching Si diodes, and transistors such as the 1N914 and 2N706 used the first supercomputer, the Control Data Corporation model ¢600, obtained their speed by doping with the gold ...

The value of specific heat for copper is390jkgsdotcfor

The value of specific heat for copper is390J/kg⋅C°,for aluminun is900J/kg⋅C°,and for water is4186J/kg⋅C° What will be the equilibrium temperature when a 215 g block of copper at 245 °C is placed in a 155 g aluminum calor ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro