Physical properties of trihydric alcoholsa trihydric, Ask an Expert

Academics

Physical properties of Trihydric alcohols

(a) Trihydric alcohol is an odourless, viscous, colourless and hygroscopic liquid.

(b) Trihydric alcohol has high boiling point that is 290°C. The high viscosity and high boiling point of glycerol are because of association through hydrogen bonding.

(d) Trihydric alcohol is non toxic in nature and sweet in taste.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9538696

Have any Question?Write your Review or question?

Related Questions in Chemistry

2k3po4aq3mgcl2aq rarr mg3po42s6kclaqthe molecular equation

2K3PO4(aq)+3MgCl2(aq) → Mg3(PO4)2(s)+6KCl(aq) The molecular equation you determined in Part B is shown above for your convenience. Examine each of the chemical species involved to determine the ions that would be present ...

Q1 sodium metal is very active with water therefore

Q1. Sodium metal is very active with water. Therefore, determining the value of a block of sodium will be impossible by water displacement. On the other hand, the density of sodium metal can be found in the chemistry han ...

How is vacuum filtration completing the purification of

How is vacuum filtration completing the purification of your sample? Where are the impurities at this point? For a recrystallization lab in organic chemistry

An analysis of an oxide of nitrogen with a molecular weight

An analysis of an oxide of nitrogen with a molecular weight of92.02 amu gave 69.57% oxygen and 30.43 % nitrogen. What is the empirical formula of the compound?

N2o5 decomposes following first order kinetics if 75 of the

N2O5 decomposes following first order kinetics. If 75% of the original sample of N2O5 has decomposed after 2240 minutes, what is the value of k, the rate constant, at this temperature(in min-1)?

If 1440 grams of rbcl are dissolved in water to make a

If 14.40 grams of RbCl are dissolved in water to make a solution of 0.224 L, the density is found to be 1.047 g/cm 3 . Calculate the molality of the solute.

Hydrogen peroxide was catalytically decomoposed and 753 ml

Hydrogen peroxide was catalytically decomoposed and 75.3 mL ofoxygen gas was collected over water at 25 degrees celsius and 742torr. What mass of oxygen was collected? (Pwater =24 torr at 25 degrees celsius)

Sodium sulfide 117 g reacts with hydrochloric acid 167 ml

Sodium sulfide (11.7 g) reacts with hydrochloric acid (16.7 ml, 12.0 M) to yield sodium chloride and hydrogen sulfide. What is the theoretical yield (g) of hydrogen sulfide?

An electron is ejected from a metal with a velocity 778

An electron is ejected from a metal with a velocity 7.78 x10^5 m/s. If the metal has a threshold frequency of 9.90 x1014 Hz, what was the wavelength of the incident photon?

What wavelength of light nm is required to eject an

What wavelength of light (nm) is required to eject an electron with a speed of 2.0 x 10 6 m/s from a metal with a threshold energy of 3.4 x 10 -18 J?

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert