Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Calculating the distance of GPS satellite from the ground.

1. How far is it from the ground to a GPS satellite straight overhead?

2. How long does it take light (or radio waves) to go from a GPS satellite overhead to the ground?

3. Let's say the time measured in problem 2 was measured by clocks on the ground. What would that time is if measured by clocks on the GPS satellite instead? (For ex apply whatever speedup/slowdown factor you got above).

4. Multiply the time in problem 3 by the speed of light to get a distance and evaluate it to the distance you had from problem 1. That gives you an idea of how far off your GPS measurements would be if you didn't take into account special and general relativity.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917182

Have any Question? 


Related Questions in Physics

1 in terms of the wavelength of the sound wave about how

1. In terms of the wavelength of the sound wave, about how far below the open end of the resonance tube is the first resonant position? 2. The speed of sound in air is 345 m/s. A tuning fork vibrates above the open end o ...

A container of acetone was accidently spilled covering the

A container of acetone was accidently spilled, covering the top, smooth surface of a laboratory bench located in a semiconductor-fabrication building. The exhaust fan for the fabrication building produced a 6 m/s air flo ...

A cat chases a mouse across a 16 m high table the mouse

A cat chases a mouse across a 1.6 m high table. The mouse steps out of the way, and the cat slides off the table and strikes the floor 1.1 m from the edge of the table. What was the cat's speed when it slid off the table ...

A race car moves 85 kmh at 55 degrees north of e what are

A race car moves 85 km/h at 55 degrees North of E. What are the E-W and N-S components of its velocity?

The longest javelin throw at the olympics covered a

The longest javelin throw at the Olympics covered a horizontal distance of 104.8 m. The athlete threw the javelin at an angle of J3CK00 above the horizontal from an initial height of 1.50 m above the ground. Ignore air r ...

Polycrystalline silicon has been used as the gate material

Polycrystalline silicon has been used as the gate material in Si MOS transistors. It is also used as a barrier layer for making contact to thin Si layers to prevent a metal conductor from penetrating and short-circuiting ...

The position of an object moving along the x axis is given

The position of an object moving along the x axis is given by x(t)=7.0t-3.0t^2 (with t in seconds, and x in meters). A) What is the average velocity during the time interval from t=0.0 s to t=2.0 s? B) What is the instan ...

Without using tunneling design the surface concentration of

Without using tunneling, design the surface concentration of the p+ and n+ surfaces of an m1/p+/n/n+/m­ 2  diode with m 1  = m 2  = aluminum so that the voltage drop across the two ohimc contacts are minimized. What meta ...

What is the maximum voltage that can be generated by a

What is the maximum voltage that can be generated by a silicon solar cell?

Figure 350 shows the tangent line approximation to fx near

Figure 3.50 shows the tangent line approximation to f(x) near x = a. (a) Find a, f(a), f'(a). (b) Estimate f(2.1) and f(1.98). Are these under- or overestimates? Which estimate would you expect to be more accurate and wh ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen