Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Determining the factors that affect the friction losses in a pipe.

A 12-inch cast iron water pipe that has been in service for 50 years is found to have extensive corrosion inside. Inspection of a section of pipe reveals that the inside diameter is half the original value and the equivalent sand roughness Ks has increased from 0.2 mm to 1 mm. describe how these conditions would affect friction losses in the pipe.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917072

Have any Question? 


Related Questions in Physics

1 give a simple reason based on device physics or charge

1. Give a simple reason based on device physics or charge store concept to show that the speed up of the recovery during switch-off transient is given by the ratio, J F /J R . Afterwards, show this also mathematically us ...

A pinball machine uses a spring launcher that is compressed

A pinball machine uses a spring launcher that is compressed 6.6 cm to launch a ball up a 17 °ramp. Assume that the pinball is a solid uniform sphere of radius r = 1.0cm and mass m = 28 g .If it is rolling without slippin ...

How to measure a classifiers quality youve just written a

How to measure a classifier's quality. You've just written a new classification algorithm and want to measure how well it performs on a test set, and compare it with other classifiers. What performance measure should you ...

When you breathe a muscle called the diaphragm reduces the

When you breathe, a muscle (called the diaphragm) reduces the pressure around your lungs and they expand to fill with air. The table shows the volume of a lung as a function of the reduction in pressure from the diaphrag ...

An object with a mass of 3 kg falls freely from rest for 3

An object with a mass of 3 kg falls freely from rest for 3 seconds. Calculate the acceleration.

Two ordinary dice are thrown repeatedly the outcome of each

Two ordinary dice are thrown repeatedly; the outcome of each throw is the sum of the two numbers. Joe Shark, who says that 6 and 8 are his lucky numbers, bets even money that a 6 will be thrown before the first 7 is thro ...

While the genome acquires information through natural

While the genome acquires information through natural selection at a rate of a few bits per generation, your brain acquires information at a greater rate. Estimate at what rate new information can be stored in long term ...

Questionyoure driving down a highway and you decide to

Question: You're driving down a highway, and you decide to accelerate flaunting the speed limit, you accelerate way up there. At one point, you're going (a) 100km/hr. Later, you're going (b) 0.25 times the speed of light ...

High voltage 100 to 400 volts and medium speed 1-20 mhz mos

High voltage (100 to 400 Volts) and medium speed (1-20 MHz) MOS transistors and integrated circuits have been designed and volume produced in 1990 to drive non-impact printers (electrostatic or xerographic printers) and ...

An 2655 kg van runs into the back of an 848 kg compact car

A(n) 2655 kg van runs into the back of a(n) 848 kg compact car at rest. They move off together at 8.8 m/s. Assuming no friction with the ground, find the initial speed of the van.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen