In the alkylation of cyclopentanone better yields are, Ask an Expert

Academics

In the alkylation of cyclopentanone, better yields are obtained by first reacting cyclopentanone with an equivalent of lithium diisopropylamde in THF and then adding the alkyl halide ratehr than mixing cyclopentanone, alkyl halide and a catalytic amount of sodium ethoxide in ethanol. exaplin this obeservation by pointing out what the problems with the second reaction conditions might be and how the first set of reaction conditions help allevite the problems.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91063002

Have any Question?Write your Review or question?

Related Questions in Chemistry

2kmno4s rarr k2mno4s mno2s o2gif 250 l of o2g is needed

2KMnO 4 (s) → K 2 MnO 4 (s) + MnO 2 (s) + O 2 (g) If 2.50 L of O 2 (g) is needed at 1.00 atm and 20°C, what mass of KMnO 4 (s) should be decomposed? Assume the decomposition of KMnO 4 (s) goes to completion.

A sealed vessel contains a gaseous mixture of h2 and excess

A sealed vessel contains a gaseous mixture of H2 and excess O2. The mixture is at 500 K and has a total pressure of 140 kPa. After all of the hydrogen is reacted, the total pressure of the system measured at the same tem ...

Questionwhat is the ph of the solution that results from

Question: What is the pH of the solution that results from mixing 10.00ml of 0.050 M perchloric acid with 30.00ml of 0.040 M barium hydroxide

How much will the temperature change when 30 g of tooth

How much will the temperature change when 3.0 g of tooth enamel (specific heat = 0.18 cal/g C) absorbs 0.80 cal of heat energy?

Give an example of when heat is released from water as it

Give an example of when heat is released from water as it undergoes a change of phase.

At a given pressure and temperature it takes 1987 sec for a

At a given pressure and temperature, it takes 198.7 sec for a 2.6 L sample of Kr to effuse through a porous membrane. How long does it take for 2.6 L Ar to effuse under the same conditions?

What is the minimum amount of 60 m h2so4nbspnecessary to

What is the minimum amount of 6.0 M H 2 SO 4 necessary to produce 25.0g of H 2 (g) according to the reaction between aluminum and sulfuric acid? 2 Al(s) + 3 H 2 SO 4 (aq) --------> Al 2 (SO 4 ) 3 (aq) + 3 H 2 (g)

The molecular weight of an unknown gas was measured by an

The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?

One liter of nitrogen n2 and one liter of carbondioxide co2

One liter of nitrogen (N 2 ) and one liter of carbondioxide (CO 2 ), initially at one atmosphere pressure, are forcedinto a single evacuated 500 mL vessel. What is the total pressure, in atmospheres,if the temperature re ...

When 514g of biphenyl c12h10 undergoes combustion in a bomb

When .514g of biphenyl (C12H10) undergoes combustion in a bomb calorimeter, the temperature rises from 25.8 degrees C to 29.4 degrees C. Find delta E(rxn) for the combustion of biphenylin kJ/mol. The heat capacity of the ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert