In given problem the explosive energy of a high explosive, Ask an Expert

Academics

In given Problem, the explosive energy of a high explosive was defined to be the lower heating value (LHV) of the detonation reaction. The heat of formation of trinitrotoluene (TNT), C₇H₅(NO₂)₃, is -54.4 MJ/kgmole, and its molecular mass is 227 kg/kgmole.

a. Find the values of a, b, c, and d in the following simplified reaction describing the detonation of TNT:

C₇H₅(NO₂)₃ → a(CO) + b(CH₄) + c(H₂O) + d(N₂)

b. Determine the explosive energy of TNT in MJ/kg.

Problem :

The explosive energy of a high explosive is defined to be the lower heating value (LHV) of the detonation reaction. The heat of formation of nitroglycerin, C₃H₅(NO₃)₃, is -354 MJ/kgmole, and its molecular mass is 227 kg/kgmole.

a. Find the values of a, b, c, and d in the following reaction describing the detonation of nitroglycerin:

C₃H₅(NO₃)₃ → a(CO₂) + b(H₂O) + c(O₂) + d(N₂)

b. Determine the explosive energy of nitroglycerin in MJ/kg.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M92100730

Have any Question?Write your Review or question?

Related Questions in Chemistry

Interpretation of reactions by ionic type equations aqueous

Interpretation of Reactions by Ionic Type Equations. Aqueous solutions of the following substances or their mixtures with water if they are only slightly soluble, are mixed. Write first the conventional equation , secon ...

Calculate the volume in milliliters of anbsp18 moll ironii

Calculate the volume in milliliters of a 1.8 mol/L iron(II) bromide solution that contains 150.g of iron(II) bromide FeBr2. Round your answer to 2 significant digits.

The molecular weight of an unknown gas was measured by an

The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?

A 0235g sample of a solid is 925 naoh and 75 caoh2 by mass

A 0.235g sample of a solid is 92.5% NaOH and 7.5% Ca(OH)2, by mass requires 45.6mL of a HCl solution for its titration. What is HCl molarity?

You have 5 ml of hcl acid unknown concentration in a 50

You have 5 mL of HCl acid (unknown concentration) in a 50 mLvolumetric flask, and bring it up to volume with deionizedwater. Calculate the molarity of the HCl by using the pH equation(pH = -log[H3O+]) , and the dilution ...

If liquid is at or above its flash point the flame spread

If liquid is at or above it's flash point, the flame spread rate is fast, and the entire pool is engulfed within seconds. In such a case, the liquid is already evaporating sufficiently to reach the lower flammability lim ...

Nitro glyerine is an explosive used by the mining industry

Nitro glyerine is an explosive used by the mining industry. It detonates according to the following equation: 4C 3 H 5 N 3 O 9 (l)→ 12CO 2 (g) + 6N 2 (g) +10H 2 O(g) + O 2 (g) What volume is occupied by the gases produce ...

Q1 in your gravimatric analysis experiment you weigh the

Q1: In your gravimatric analysis experiment, you weigh the precipitate of AgCl in a filtering crucible. You have to weight your filtering crucible first (three weighing measurement), then do the filtration. After drying ...

Give an example of when heat is released from water as it

Give an example of when heat is released from water as it undergoes a change of phase.

A saturated solution of sroh2aq at 25 degrees celcius has

A saturated solution of Sr(OH)2(aq) at 25 degrees Celcius has measured a pH of 13.5. Estimate the solubility of Sr(OH)2(aq) in water at 25 degrees Celsius

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert