Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

find out the resistance of a RL circuit.

In an assured RL time constant circuit, it takes 135 msec for the current to reach maximum after the switch is closed. If the inductance is 4 henrys, what is the value of circuit resistance?

A) 670 ohms
B) 148 ohms
C) 0.670 ohms
D) 0.148 ohms

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917280

Have any Question? 


Related Questions in Physics

A thin polymer film contains some residual liquid solvent

A thin polymer film contains some residual liquid solvent. It is desired to evaporate the solvent (n-hexane, solute A) from the polymer using the process shown below. Both sides of the polymer film are exposed to the cro ...

1 what is the probability of block error of the n k hamming

1. What is the probability of block error of the (N, K) Hamming code to leading order, when the code is used for a binary symmetric channel with noise density f? 2. Prove that there exist families of codes with ‘bad' dis ...

On a certain day the barometric pressure at sea level is

On a certain day the barometric pressure at sea level is 30.1 in. Hg, and the temperature is 708F. The pressure gage in an airplane in flight indicates a pressure of 10.6 psia, and the temperature gage shows the air temp ...

A diffraction grating has 593 lines rulings per mm when

A diffraction grating has 593 lines (rulings) per mm. When white light shines on the grating, all wavelengths experience constructive interference at the centre of the diffraction pattern, so the central maximum (m = 0) ...

What would be the best way to extract the entropy from the

What would be the best way to extract the entropy from the Monte Carlo simulations? What would be the best way to obtain the entropy and the heat capacity from the partition function computation?

A piece of hot iron c 450 jkg degc of mass 0500 kg and

A piece of hot iron (c = 450 J/kg .°C) of mass 0.500 kg and temperature 120° C is dunked into 2.00 liters of water at room temperature (20.0° C) a. What is the final temperature of the mix? b. What is the amount of energ ...

Two flywheels one with moment of inertial 240kgm2 and one

Two flywheels, one with moment of inertial 240kgm^2 and one with moment of inertial 150kgm^2 turn on the same shaft. The First wheel is fixed on the shaft, the second one is connected by a clutch, so that it can be made ...

Determine the value of henrys law constant in pakgm3 of

Determine the value of Henry's law constant, in Pa/(kg/m 3 ) of chlorine for the chlorine-water system. The following equilibrium data at 293 K were reported in the Chemical Engineering Handbook.

The contact transient example shown in given figure

The contact transient example shown in given Figure illustrates electrons transferred from the metal gate to the p-type Si that is based on a specific set of assumptions on the material pro1cities of the metal and Si. Co ...

A solenoid of inductance 50mh and resistance 10 ohms is

A solenoid of inductance 50mH and resistance 10 ohms is connected to a battery 6v.FInd the time elapsed before the current acquires half of its steady state value.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen