Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

problem 1:

Illustrate out the term proximate analysis of the coal. Discuss its importance.

problem 2:

Illustrate out the manufacture of the gasoline by Fisher – Tropsch procedure.

problem 3:

Critically discuss the refining of crude oil. Discuss the differ fractions obtained from petroleum.

problem 4:

What do you understand by knocking in IC engines? Discuss the mechanism in of the knocking in chemical terms.

problem 5:

Illustrate out the mechanism of the differential aeration corrosion. Provide two instances where differential aeration effect is seen.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M912285

Have any Question? 


Related Questions in Physics

Consider 10 moles of nitrogen within a cylinder witha cross

Consider 10 moles of nitrogen within a cylinder with.a cross sectional area o f 1 m^2. Assume that the cover ("cap") ofthe cylinder, is a disk which can slide frictionlessly within the cylinder. Assume that the cap makes ...

A certain object is composed of a solid sphere of mass 15

A certain object is composed of a solid sphere of mass 15 kg and radius 0.5 m, connected to two thin rods of length 2 m and mass 5 kg. The object is initially oriented in the vertical plane and then released. Gravity the ...

In the circuit the capacitor is fully charged when switch s

In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed for the potential energy stored by the circuit to be equally distributed between the capacitor and inductor. The capacitan ...

Fnd the equations of the tangent lines to the graph of fx

Find the equations of the tangent lines to the graph of f(x) = sin x at x = 0 and at x = π/3. Use each tangent line to approximate sin(π/6). Would you expect these results to be equally accurate, since they are taken equ ...

For a boat to float in a tidal bay the water must be at

For a boat to float in a tidal bay, the water must be at least 2.5 meters deep. The depth of water around the boat, d(t), in meters, where t is measured in hours since midnight, is (a) What is the period of the tides in ...

In 2011 the greenland ice sheet was melting at a rate

In 2011, the Greenland Ice Sheet was melting at a rate between 82 and 224 cubic km per year. (a) What derivative does this tell us about? Define the function and give units for each variable. (b) What numerical statement ...

When the student flicks a 100 g marble its position vector

When the student flicks a 10.0 g marble, its position vector is as follows r(t) = (0.2 m/s³) t³ - (0.1 m/s) t. Find its momentum as a function of time. What is the momentum and net force acting on the marble at t = 3 sec ...

Science the future and reflections on the course please

"Science, the Future, and Reflections on the Course" Please respond to the following: Identify the main developments in science that you find most fascinating. List at least two (2) topics that you wish you could learn m ...

1 the population of the ukraine fell from 457 million in

1. The population of the Ukraine fell from 45.7 million in 2009 to 45.42 million in 2010.40 Assuming exponential decline, in what year is the population predicted to be 45 million? 2. Find the half-life of a radioactive ...

A 349 rads 33rpm record has a 503-khz tone cut in the

A 3.49 rad/s (33rpm) record has a 5.03-kHz tone cut in the groove. If the groove is located 0.100 m from the center of the record (see drawing), what is the "wavelength" in the groove?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro