Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

find out the time required by the current to reach an initial value in an inductive discharge circuit.

How long will it take for the current to reach 36.7 percent of its initial value in an inductive discharge circuit if R equals 1000ohms and L equals 4 henrys?

A) 40 sec
B) 10 sec
C) 0.004 sec
D) 0.001 sec

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917269

Have any Question? 


Related Questions in Physics

A baseball hit at an angle of theta to the horizontal with

A baseball hit at an angle of θ to the horizontal with initial velocity v0 has horizontal range, R, given by Here g is the acceleration due to gravity. Sketch R as a function of θ for 0 ≤ θ ≤ π/2. What angle gives the ma ...

The gravitational attraction f between the earth and a

The gravitational attraction, F, between the earth and a satellite of mass m at a distance r from the center of the earth is given by where M is the mass of the earth, and G is a constant. Find the rate of change of forc ...

Visible light is incident on an oil film n 151 coating a

Visible light is incident on an oil film (n = 1.51) coating a puddle of water. What minimum oil thickness will maximize the reflection of each of these colors: blue (460 nm) and yellow (580 nm).

The saint louis arch can be approximated by using a

The Saint Louis Arch can be approximated by using a function of the form y = b - a cosh(x/a). Putting the origin on the ground in the center of the arch and the yaxis upward, find an approximate equation for the arch giv ...

A radioactive isotope is being produced at a constant rate

A radioactive isotope is being produced at a constant rate dN/dt - R in an experiment. The isotope has a half-life Show that after a time t >> t1/2, the number of active nuclei will become constant. Find the value of thi ...

The air in a factory is being filtered so that the quantity

The air in a factory is being filtered so that the quantity of a pollutant, P (in mg/liter), is decreasing according to the function P = P0e-kt, where t is time in hours. If 10% of the pollution is removed in the first f ...

Let the power spectrum be a gaussian function of frequency

Let the power spectrum be a Gaussian function of frequency. Since the Fourier transform of a Gaussian is a Gaussian, the autocovariance function corresponding to this power spectrum is a Gaussian function of separation. ...

The income that a company receives from selling an item is

The income that a company receives from selling an item is called the revenue. Production decisions are based, in part, on how revenue changes if the quantity sold changes; that is, on the rate of change of revenue with ...

Find the impurity concentrations necessary to dope the

Find the impurity concentrations necessary to dope the polysilicon gate so that the surface is flat-banded. V S =0, intrinsic, V S =V F , and at the threshold, V S =2V F . The last is known as the zero threshold device b ...

Ammonia nh3 in air is being absorbed into water within the

Ammonia, NH 3 , in air is being absorbed into water within the enclosed tank shown in the figure below. The liquid and gas phases are both well mixed, and mass transfer occurs only at the exposed gas-liquid interface. Th ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro