Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

find out the time required by the current to reach an initial value in an inductive discharge circuit.

How long will it take for the current to reach 36.7 percent of its initial value in an inductive discharge circuit if R equals 1000ohms and L equals 4 henrys?

A) 40 sec
B) 10 sec
C) 0.004 sec
D) 0.001 sec

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917268

Have any Question? 


Related Questions in Physics

How well does your existing resume convince employers that

How well does your existing resume convince employers that you're right for the job?  In a short essay (1.5 to 2 pages), address the following questions: Does your existing resume reflect who you are as an employee? As a ...

An accelerating sports car goes from 0 mph to 60 mph in

An accelerating sports car goes from 0 mph to 60 mph in five seconds. Its velocity is given in the following table, converted from miles per hour to feet per second, so that all time measurements are in seconds. (Note: 1 ...

A process is being developed to produce carbonated

A process is being developed to produce carbonated beverages. As part of this process, a wetted-wall absorption column of 2.0 m length will be used to dissolve carbon dioxide, CO 2 , gas into water. Pure mountain spring ...

A race car completes a lap on a 1600 m long track with an

A race car completes a lap on a 1600 m long track with an average speed of 250 km/h. If the car's average speed on the first half of the track was 205 km/h, what was its average speed on the second half?

1 a circular coin of diameter a is thrown onto a square

1. A circular coin of diameter a is thrown onto a square grid whose squares are b × b. a. Buffon's needle. A needle of length a is thrown onto a plane covered with equally spaced parallel lines with separation b. What is ...

Your mass is 50 kg suppose you are standing on a scale in

Your mass is 50 kg. Suppose you are standing on a scale in an elevator that starts moving up and increases its speed at the rate of 3 m/s every second. What would be the reading on the scale?

The height of a sand dune in centimeters is represented by

The height of a sand dune (in centimeters) is represented by f(t) = 700 - 3t 2 , where t is measured in years since 2005. Find f(5) and f'(5). Using units, explain what each means in terms of the sand dune.

A use a computer algebra system to find and simplify the

(a) Use a computer algebra system to find and simplify the derivative of the given function. (b) Without a computer algebra system, use differentiation rules to calculate the derivative. Make sure that the answer simplif ...

Tectonic plates are large segments of the earths crust that

Tectonic plates are large segments of the Earth's crust that move slowly. Suppose one such plate has an average speed of 4.8 cm per year. (a) What distance does it move in 50 seconds at this speed? (b) What is its speed ...

1 compute the thermal equilibrium constant k of the

1. Compute the thermal equilibrium constant K of the electron-hole pair generation-recombination reaction in silicon at 300K, 600K and 900K. 2. A test charge Is generated Inside a pure Si at T=300K. How long does it take ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro