High power lasers are used to cpmpress a plasma a gas, Ask an Expert

Academics

High power lasers are used to cpmpress a plasma (a gas ofcharged particles) by radiation pressure. A laser generatingradiation pulses with peak power 1.5 x 10^3 MW is focused onto 1.0mm^2 of high-electron density plasma. Find the pressure exerted on the plasma if the plasma reflects all the light beamsdirectly back along their paths.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91099543

Have any Question?Write your Review or question?

Related Questions in Physics

Question 1rob was supposed to spend his two-week school

Question 1: Rob was supposed to spend his two-week school work experience at his local auto-repair shop. Unfortunately, his time on the job only lasted two days. On day two, Rob was asked to get the 1-liter air tool oil ...

In chemical changes new substances are formed do the atoms

In chemical changes, new substances are formed. Do the atoms involved actually change? If not, what has changed? How would you help your students visualize this?

Question a proton is accelerated from rest through a

Question: A proton is accelerated from rest through a potential difference V0 and gains a speed v0. If it were accelerated instead through a potential difference of 2V0, it would gain a speed...?

Question positive point charges q 700uc and q 400uc are

Question: Positive point charges q = 7.00uC and q'= 4.00uC are moving relative to an observer at point P, as shown in the figure (Figure 1). The distance d is 0.130m , v = 4.60 x 10^6 m/s , and v'= 9.20 x 10^6 m/s Part A ...

Question the power rating on a light bulb indicates how

Question: The power rating on a light bulb indicates how much power it would dissipate when it is hooked up to the standard household voltage of 120 V (this rating does not mean that the light bulb always dissipates the ...

Question a series rlc circuit of r 200 ohm l 0900 h and c

Question: A series RLC circuit of R = 200 ohm, L = 0.900 H and C = 2.00 uF carries an rms current of 0.250 A with a frequency of 100 Hz. (a) What is the average rate at which electrical energy isconverted to heat in the ...

A ball rolls off a table with a horizontal velocity of 5 ms

A ball rolls off a table with a horizontal velocity of 5 m/s if takes 0.6 seconds for it to reach the floor a) what's the vertical component of the ball's velocity just before it hits the floor b) what's the horizontal c ...

Question a small object a electrically charged creates an

Question: A small object A, electrically charged, creates an electric field. At a point P located 0.250m directly north of A, the field has a value of 40.0N/C directed to the south. What is the charge of object A? If a s ...

Question a regulation table tennis ball has a mass of 27g

Question: A regulation table tennis ball has a mass of 2.7g and is 40mm in diameter. What is its moment of inertia about an axis that passes through its center? The response must be typed, single spaced, must be in times ...

Problem here we ponder a few issues related to

Problem: Here we ponder a few issues related to thermodynamic reversihilityfirrerversihility. Recall that a process is said to be thermodynamically reversible if and only if there exists an e?ecing process. That can retu ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert