Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: Give the significance of Distribution system and describe the various factors influencing the distribution system planning.

problem 2: What do you mean by the term Load forecasting? Describe the different factors influencing load forecast?

problem 3: Define the given terms:

a) Load factor
b) Demand factor
c) Utilization factor
d) Plant use factor
e) Diversity factor
f) Load diversity
g) Load factor
h) Loss factor

Obtain the relationship between load factor and loss factor under different conditions.

problem 4: Give the categorization of Loads and describe their characteristics.

problem 5: What is meant by the term Load Modeling? Give its characteristics.

problem 6: Draw the one line diagram of Radial type primary feeder, loop type primary feeder and mention their benefits and drawbacks.

problem 7: State the various voltage levels of primary and secondary distribution systems.

problem 8: What is meant by the term primary network? Draw primary network system and state whether it is more reliable when compared to other networks or not and justify that statement.

problem 9: Illustrate different factors which influence the selection of Primary feeder rating?

problem 10: What is meant by the term Primary feeder loading? Illustrate different factors influencing the primary feeder loading? 

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M93663

Have any Question? 


Related Questions in Electrical & Electronics

The pressure rise across a pump p this term is proportional

The pressure rise across a pump P (this term is proportional to the head developed by the pump) may be considered to be affected by the fluid density ρ, the angular velocity ω, the impeller diameter D, the volumetric rat ...

1 distinguish between centralized and decentralized p2p

1. Distinguish between centralized and decentralized P2P networks. 2. What are the advantages and disadvantages of a centralized P2P network? 3. What are the advantages and disadvantages of a decentralized P2P network? 4 ...

1 explain why rtp cannot be used as a transport-layer

1. Explain why RTP cannot be used as a transport-layer protocol without being run on the top of another transport-layer protocol such as UDP. 2. Both TCP and RTP use sequence numbers. Do sequence numbers in these two pro ...

Consider the problem of identifying the nonlinear

Consider the problem of identifying the nonlinear discrete-time system in (9.9.4) using a raised-cosine RBF network. Let the number of past inputs be m = 1 and the number of past outputs be n = 1. Suppose the range of va ...

1 express equation in terms of the flow rate and the pipe

1. Express equation in terms of the flow rate and the pipe diameter. If the pipe diameter is doubled at constant pressure drop, what percentage change will occur in the flow rate? 2. A 40-km-long pipeline delivers petrol ...

In a chord network with m 4 node n2 has the following

In a Chord network with m = 4, node N2 has the following finger-table values: N4, N7, N10, and N12. For each of the following keys, first find if N2 is the predecessor of the key. If the answer is no, find which node (th ...

1 what is meant by the dominant mode why are waveguides

1. What is meant by the dominant mode? Why are waveguides designed so that they propagate only the dominant mode? 2. Why is the dimension b of a rectangular waveguide generally chosen to be less than or equal to one-half ...

1 discuss the input behavior of a short-circuited line for

1. Discuss the input behavior of a short-circuited line for frequencies slightly beyond those for which the quasistatic approximation is valid. 2. What are the boundary conditions for the voltage and current at the junct ...

1 what is the brewster angle what is the polarization of

1. What is the Brewster angle? What is the polarization of the reflected wave for an elliptically polarized wave incident on a dielectric interface at the Brewster angle? Discuss an application of the Brewster angle effe ...

For the structure of figure 610 continue the analysis

For the structure of Figure 6.10, continue the analysis beyond the quasistatic extension to obtain the input impedance correct to the third power in . Determine the equivalent circuit.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro