Explain the formation of line spectrum in the balmer series, Ask an Expert

Academics

Explain the formation of line spectrum in the Balmer series of hydrogen atom. If the emitted photon has a wavelength of 434nm, determine the transition of electron that occurs. And calculate the energy of the line with the lowest energy in the Balmer series in kJ/mol.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91019552

Have any Question?Write your Review or question?

Related Questions in Chemistry

A power plant converts the heat energy in coal to

A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...

It takes 378 ml of 02114 m naoh to neutralize 193 ml of an

It takes 37.8 mL of 0.2114 M NaOH to neutralize 19.3 mL of an oxalic acid solution with an unknown concentration. Calculate the actual concentration of this oxalic acid solution. Don't forget to look at the balanced equa ...

A sample of cobalt ii chloride hydrate starts with a mass

A sample of cobalt (II) chloride hydrate starts with a mass of 3.35 g. After heating, the sample mass is 1.83 g. What is the molar ratio of water to cobalt chloride? What is the correct chemical formula

Assume that you dissolve 102 g of a mixture of naoh and

Assume that you dissolve 10.2 g of a mixture of NaOH and Ba(OH)2 in 227.0 mL of water and titrate with 1.47M hydrochloric acid. The titration is complete when 107.8 mL of the acid has been added. What is the mass (in gra ...

A watch glass and filter paper weighing 41060g was used to

A watch glass and Filter paper weighing 41.060g was used to collect the CuSCN precipitate in this experiment. After drying, the precipitate, watch glass, and filter paper weighed 42.525g. If the sample alloy used for the ...

A metal slug weighing 1632g is added to a flask with a

A metal slug weighing 16.32g is added to a flask with a volumeof 52.6 mL. it is found that, 40.2 g of methanol (d = 0.791 g/mL)must be added to the metal to fill the flask. What is the density of the metal in g/mL?

You have 5 ml of hcl acid unknown concentration in a 50

You have 5 mL of HCl acid (unknown concentration) in a 50 mLvolumetric flask, and bring it up to volume with deionizedwater. Calculate the molarity of the HCl by using the pH equation(pH = -log[H3O+]) , and the dilution ...

1-write balanced equation for the double-replacement

1-Write balanced equation for the double-replacement precipitation reaction described, using the smallest possible integer coefficients. A precipitate forms when aqueous solutions of nickel(II) iodide and potassium c ...

Ttrate the base trimethylamine tma with 0126 m hcl ch3naq

Titrate the base trimethylamine (TMA) with 0.126 M HCl. (CH) 3 N(aq) + H 2 O(l) (CH 3 ) 3 NH+(aq) + OH-(aq) Kb = 6.45 x 10 -5 There are 0.00615 moles of TMA in 42.5 mL H 2 O before titration begins. What percent of TMA i ...

A chemist must preparenbsp725 ml ofnbsp275 mm aqueous

A chemist must prepare 725. mL of 275. mM aqueous copper(II) sulfate CuSO4 working solution. He'll do this by pouring out some 0.316 M aqueous copper(II) sulfate stock solution into a graduated cylinder and diluting it w ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert