Explain the effect of that mistake on the calculated, Ask an Expert

Academics

At the beginning of a titration to standardize the NaOH solution, Student A adjusted very carefully the initial burette volume to 0.00mL. But he did not notice an important air bubble in the tip of the burette. At the end of the titration, the air bubble is gone. Explain the effect of that mistake on the calculated molarity MB. (Will the experimental MB calculated by Student A be higher or lower than the true MB value?)

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9448649

Have any Question?Write your Review or question?

Related Questions in Chemistry

To standardize a solution of naoh one uses a primary

To standardize a solution of NaOH, one uses a primary standard called potassium hydrogen phthalate (KHP for short). It is a monoprotic acid that can be obtained extremely pure and dried to a constant weigh out 0.556g of ...

An electron is ejected from a metal with a velocity 778

An electron is ejected from a metal with a velocity 7.78 x10^5 m/s. If the metal has a threshold frequency of 9.90 x1014 Hz, what was the wavelength of the incident photon?

You are required to read the following case study and

You are required to read the following case study and prepare a Project Feasibility Study and Timeline based on the information contained in the case study. Residential Duplex Development Project You own a real estate ...

What is the calculation of the new temperature of a gas

What is the calculation of the new temperature of a gas sample has an original volume of 740 ml when collected at 710 mm and 35 o C when the volume becomes 460 ml at 1.20 atm?

Consider the following reactiona gnbspnbspb grarrc

Consider the following reaction. A (g) + B (g) → C (g) + D (g) *In one experiment the concentration of A (g) was monitored in the presence of a large excess of B (g) ( [B] o = 0.750 M ) . Time (s) [A] (mol/L) 0.00 6.00 ...

The threshold wavelength for the photoelectric effect for

The threshold wavelength for the photoelectric effect for silver is 262nm. What is the work function for silver and what is the maximum KE of an emitted electron if the incident light has a wavelength of 212nm?

The heat fusion of pure silicon is 434 kjmol how much

The heat fusion of pure silicon is 43.4 kJ/mol. How much energy would be needed to melt a 5.24 - g sample of silicon at its melting point of 1693 K?

Asolution is prepared by dissolving 2244 grams of acetic

Asolution is prepared by dissolving 22.44 grams of acetic acid inenough water to make250.0 mL of solution. A 25.00-mL aliquot of NaOH solution is thentitrated with the acetic acid solution. 37.28 mL of the acetic acid so ...

Assignment application planned change in a department or

Assignment: Application: Planned Change in a Department or Unit Health care organizations are continuously immersed in change from the emergence of new policies, to promote quality care and improve patient safety to keep ...

2 moles of a compound are allowed to react ina foam coffee

2 moles of a compound are allowed to react ina foam coffee cup that contains 197 grams of water. The reaction caused the temperature of the water to rise from 21 to24.7 degrees Celsius. What is the enthalpy of this react ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert