Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Q1. Differentiate between the given three types of plain carbon steels.

a) Eutectoid
b) Hypoeutectoid
c) Hypereutectoid

Q2. A 0.90% C hypereutectoid plain carbon steel is slowly cooled from 900°C to a temperature just slightly above the 723°C. Compute the weight percent proeutectoid cementite and weight percent austenite present in this steel.

Q3. A 1.10% C hypereutectoid plain carbon steel is slowly cooled from 900°C to a temperature just slightly below the 723°C.

a) Compute the weight percent preutectoid cementite present in the steel

b) Compute the weight percent eutectoid cementite and the weight percent eutectoid ferrite present in steel.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M99655

Have any Question? 


Related Questions in Physics

1 which of the quantities listed below are flow properties

1. Which of the quantities listed below are flow properties and which are fluid properties? pressure temperature velocity density stress speed of sound specific heat pressure gradient 2. For a fluid of density ρ in which ...

An infants pulse rate is measured to be 156 plusmn 4 beats

An infant's pulse rate is measured to be 156 ± 4 beats per minute. What is the percent uncertainty in this measurement? (Note that percent uncertainties should be reported to two significant figures.)

How many electron-hole pairs are generated per second in si

How many electron-hole pairs are generated per second in Si by interband impact generation at x 1  If E(x 1 )...3x10 5 V/cm. If N(x 1 )=n 1 =1.0x10 10 cm -3 , what is the number of electron-hole pairs generated per unit ...

Anbsp1000 kg aircraft goingnbsp25 ms collides with

A 1000 kg aircraft going 25 m/s collides with a 1500kg aircraft that is parked and they stick together after the collision and are going 10 m/s after the collision. If they skid for 6.6 seconds before stopping, how far d ...

The transition matrix tx x defined by a complete update of

The transition matrix T(x'; x) defined by a complete update of all variables in some fixed order does not satisfy detailed balance. If the updates were in a random order, then T would be symmetric. Investigate, for the t ...

A rock of 350 kg is found at the top of a mountain that is

A rock of 350 kg is found at the top of a mountain that is 1250-m high. Find the potential energy with respect to the bottom of the mountain (g = 9.8 m/s2)

Asignment emtquestion 1the value of eat prho 2phi 40oz

Assignment: EMT Question 1: The value of Eat P(ρ = 2,φ = 40 o ,z = 3) is given as = 100aρ- 200aφ + 300azV/m. Determine the incremental work required to move a20 μC charge a distance of 6μm: a. in the direction of aρ; b. ...

Choose two of the following questions to respond to you

Choose two of the following questions to respond to. You should make sure to let us know which question you are responding to. Respond to the questions you choose as thoughtfully and thoroughly as possible, drawing from ...

The wetted-well column shown in figure 304 is used to

The wetted-well column shown in Figure 30.4 is used to humidify a pressurized air stream. Bone-dry air (containing no water vapor) at 2.0 atm and 27°C is introduced to the bottom of the column at a volumetric flow rate o ...

The voltage v in volts in an electrical outlet is given as

The voltage, V , in volts, in an electrical outlet is given as a function of time, t, in seconds, by the function V = 156 cos(120πt). (a) Give an expression for the rate of change of voltage with respect to time. (b) Is ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro