Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Determine resistance of an oven and the current drawn by the oven, and finding the time necessary to heat 400 mL of water.

A 1300 W microwave oven is connected to a 120 V source. (a) What is the resistance of the oven? (b) How much current does the oven draw? (c) How long will it take to heat 400 mL of water from room temperature at 20°C to boiling at 100°C? (Suppose 80 percent efficiency) (d) How much would this cost at 13 cents/where? (Specific heat of water: 4.186 J/g/K)

Physics, Academics

  • Category:- Physics
  • Reference No.:- M916999

Have any Question? 


Related Questions in Physics

A snowboarder on a slope starts from rest and reaches a

A snowboarder on a slope starts from rest and reaches a speed of 1.1 m/s after 8.2 s. (a) What is the magnitude of the snowboarder's average acceleration? m/s2 (b) How far does the snowboarder travel in this time?

At a time t seconds after it is thrown up in the air a

At a time t seconds after it is thrown up in the air, a tomato is at a height of f(t) = -4.9t 2 + 25t+ 3 meters. (a) What is the average velocity of the tomato during the first 2 seconds? Give units. (b) Find (exactly) t ...

A chemotherapeutic agent is initially present at a blood

A chemotherapeutic agent is initially present at a blood plasma concentration level of 50 μg/100 ml. If after 3 hours the concentration level is 20 μg/100 ml, compute the physiological half-life of the drug in hours. You ...

Consider the waste treatment operation proposed in the

Consider the waste treatment operation proposed in the figure below. In this process, wastewater conraining a TCE concentration of 50 g mol/m 3  enters a clarifier, which is essentially a shallow, well-mixed tank with an ...

An inhomogeneously doped n-type semiconductor is at thermal

An inhomogeneously doped n-type semiconductor is at thermal and electrical equilibria. The donor concentration is given by N DD (x) = A•exp(-ax) where A and a are constants. The variation of N DD  with position is slow s ...

Double-slit experiment a suppose you illuminate the slits

Double-slit experiment. (a) Suppose you illuminate the slits with 589 nm yellow sodium light and observe a 4.5 cm bright-fringe spacing on a screen 1.75 m away. What's the slit spacing? (b) A double-slit system with slit ...

Suppose that one weekend day a hiker exerts 200 watts of

Suppose that one weekend day a hiker exerts 200 Watts of power while ascending 300 meters on a steep trail without a pack. The hiker repeats this trip the following weekend but is carrying an additional 10 kilograms in a ...

Assume that a sequence of symbols from the ensemble x

Assume that a sequence of symbols from the ensemble X introduced at the beginning of this chapter is compressed using the code C 3 . Imagine picking one bit at random from the binary encoded sequence c = c(x 1 )c(x 2 )c( ...

A np hetero junction diode of the same donor and acceptor

A n+/p hetero junction diode of the same donor and acceptor dopant concentrations and areas as the Si homo junction diode above is known to have a layer of interfacial traps located at the metallurgical boundary. What is ...

1 hamming code can correct any one error might there be a

1. Hamming code can correct any one error; might there be a (14, 8) code that can correct any two errors? Optional extra: Does the answer to this question depend on whether the code is linear or nonlinear? 2. Design an e ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen