+61-413 786 465
info@mywordsolution.com
Home >> Chemistry
Describe six physical and six chemical changes. Explain why each is a physical or chemical change.
Chemistry, Academics
Do you notice any trends or can you make any generalizations about where certain types of liquids fall on the pH scale?
The following sequence of reactions occurs in the commercial production of aqueous nitcric acid: 4NH3(g)+ 5O2(g) -> 4NO2 (g) + 6H2O(l) ΔH = -907 kJ 2NO(g) + O2(g) ? 2NO2(g) ΔH= -113 kJ 3NO2 + H2O(l) -> 2HNO3(aq) + NO(g) ...
Q1. Sodium metal is very active with water. Therefore, determining the value of a block of sodium will be impossible by water displacement. On the other hand, the density of sodium metal can be found in the chemistry han ...
An electron is ejected from a metal with a velocity 7.78 x10^5 m/s. If the metal has a threshold frequency of 9.90 x1014 Hz, what was the wavelength of the incident photon?
A 42.60 gram sample of a hydrate of BaI 2 was heated thoroughly in a porcelain crucible, until its weight remained constant. After heating, 39.01 grams of the dehydrated compound remained. What is the formula of th ...
Suppose that a student is determining the total base content of an antacid tablet by performing a back titration. He/she weighs out a .3012g portion of a tablet whose total weight is 1.5312g, dissolves this in exactly 40 ...
What are the benefits of measuring the absorbance at the maximum absorbance wavelength? If light has a wavelength of 756 nm, what is the wavelength in centimeters? What is the wavelength in inches?
The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?
A chemist must dilute 37.4 mL of 8.08 μM aqueous mercury(I) chloride (Hg2Cl2) solution until the concentration falls to 2.00 μM. He'll do this by adding distilled water to the solution until it reaches a certain final vo ...
A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...
Start excelling in your Courses, Get help with Assignment Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.
Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate
Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p
Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As
Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int
Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As