Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

problem 1:

a) Describe in brief the method of CMRR measurement in an op-amp.
b) Derive an expression for the gain in inverting amplifier by using op-amp.

problem 2:

a) With a neat circuit diagram, describe the working of phase shift oscillation.
b) Describe the working of IC regulated power supply.

problem 3:

a) Describe the TEM wave in the coaxial line resonant cavities.
b) Describe the working of microwave resonators.

problem 4:

a) Describe the production of the FM waves.
b) With a neat diagram describe the working of Foster-seeley discriminator.

problem 5:

a) State and describe the De Morgan’s theorems.
b) Describe the operation of 8-bit multiplexer.

problem 6:

a) Describe the working of JK-flip-flop with an essential diagram.
b) Describe the operation of shift register.

problem 7:

a) Describe the addressing modes of 8085 up.
b) prepare a memory language program to add two 8 bit numbers.

problem 8:

a) Describe the architectural diagram of 8086 up and describe each part in detail.
b) describe the instruction set of 8086 up.

problem 9: prepare notes on any two of the given:

a) Class B pushfull power amplifier.
b) Magic T
c) Super heterodyne receiver.
d) A/D and D/Converters

Physics, Academics

  • Category:- Physics
  • Reference No.:- M95020

Have any Question? 


Related Questions in Physics

In free vibrations for dynamics are there any equations

In free vibrations for dynamics. Are there any equations that are specific to cases involving over damped systems, underdamped systems and critically damped systems? It would be of great help to know if there was a simpl ...

How many bits are needed to specify a selection of k

How many bits are needed to specify a selection of K objects from N objects? (N and K are assumed to be known and the selection of K objects is unordered.) How might such a selection be made at random without being waste ...

How can you use a coin to create a random ranking of 3

How can you use a coin to create a random ranking of 3 people? Construct a solution that uses exact sampling. For example, you could apply exact sampling to a Markov chain in which the coin is repeatedly used alternately ...

An inhomogeneously doped si sample is at thermal and

An inhomogeneously doped Si sample is at thermal and electrical equilibrium. By some nonequilibrium measurements at T = 290.14K, it was determined that this Si sample contains an equilibrium internal electric field of 10 ...

Two blocks having masses m1 and m2 are connected to each

Two blocks having masses m1 and m2 are connected to each other by a light cord that passes over two identical frictionless pulleys, each having a moment of inertia I and radius R, as shown in the figure. The arrows show ...

Consider the function fx a find and sketch fx and the

Consider the function f(x) = . (a) Find and sketch f(x) and the tangent line approximation to f(x) near x = 4. (b) Compare the true value of f(4.1) with the value obtained by using the tangent line approximation. (c) Com ...

1 at a finite temperature many electron-hole pairs are

1. At a finite temperature, many electron-hole pairs are created due to the thermal vibration of the atomic cores. What is the minimum photon energy needed to release an electron from the silicon surface into vacuum? 2. ...

From the top of a cliff a person throws a stone straight

From the top of a cliff, a person throws a stone straight downward. The initial speed of the stone just after leaving the person's hand is 8.9 m/s. (a) What is the acceleration (magnitude and direction) of the stone whil ...

Bullets of mass22g are fired in parallel paths with speeds

Bullets of mass2.2g are fired in parallel paths with speeds of216m/s through a hole2.0mm in diameter. How far from the hole must you be to detect a1.4cm diameter spread in the beam of bullets?

1 sketch the graph of the height of a particle against time

1. Sketch the graph of the height of a particle against time if velocity is positive and acceleration is negative. 2. The position of a particle moving along the x-axis is given by s(t)=5t 2 + 3. Use difference quotients ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen