Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

problem1) If you were halfway between Equator and South Pole and one-quarter of the way around Earth to the west of the of the Prime Meridian, what would be your longitude and Latitude?    

problem2) You are at 100 N and 900E, you move to a new location which is 250 south and 400 west of your present location. Determine your new latitudinal/longitudinal location?

problem3) You are at 200 S and 1650 E, you move to new location which is 450 north and 500east from your present location. What is your new latitudinal/longitudinal position?     

problem4) If it is 7:30 PM, Thursday in Winnipeg, Manitoba, Canada (970 W), Find out the time in Harare, Zimbabwe (310 E).                

problem5) If you depart from San Francisco International Airport at 10:00 PM on Tuesday, what day and time would you arrive in Auckland, New Zealand (1750 E), suppose a flight time of 14 hours.

problem6) Convert azimuth values listed below to quadrant angles

• 1270 (S 530E)

• 240

• 3050

• 1970

• 850

problem7) Convert quadrant bearings below to azimuths

• S 710 W (2510)

• N 100 W

• N 430 E

• S 300 E

• S 100 W

Dynamic Earth

problem8) How do clastic sedimentary rocks differ?           

problem9) What are the metamorphic equivalents of:

• Sandstone

• Limestone

• Shale

• Granite

• basalt

Physics, Academics

  • Category:- Physics
  • Reference No.:- M93738

Have any Question? 


Related Questions in Physics

The bay of fundy in canada has the largest tides in the

The Bay of Fundy in Canada has the largest tides in the world. The difference between low and high water levels is 15 meters (nearly 50 feet). At a particular point the depth of the water, y meters, is given as a functio ...

Dependence on crossover mechanism in the simple model of

Dependence on crossover mechanism. In the simple model of sex, each bit is taken at random from one of the two parents, that is, we allow crossovers to occur with probability 50% between any two adjacent nucleotides. How ...

The blackbody radiation emitted from a furnace peaks at a

The blackbody radiation emitted from a furnace peaks at a wavelength of 2.7 10-6 m(0.0000027 m). What is the temperature inside the furnace?

A classic example of a constrained channel with variable

A classic example of a constrained channel with variable symbol durations is the ‘Morse' channel, whose symbols are the constraints are that spaces may only be followed by dots and dashes. Find the capacity of this chann ...

The demand function for a certain product q dp is linear

The demand function for a certain product, q = D(p), is linear, where p is the price per item in dollars and q is the quantity demanded. If p increases by $5, market research shows that q drops by two items. In addition, ...

Each of the graphs in figure 174 is of a polynomial the

Each of the graphs in Figure 1.74 is of a polynomial. The windows are large enough to show end behavior. (a) What is the minimum possible degree of the polynomial? (b) Is the leading coefficient of the polynomial positiv ...

How does period depend on amplitude of the oscillation

How does period depend on amplitude of the oscillation? Specifically, do you think bigger-amplitude motion takes more time, less time, or the same amount of time as smaller-amplitude motion?

The angular velocity of a 755 g wheel 150 cm in diameter is

The angular velocity of a 755 g wheel 15.0 cm in diameter is given by the equation ω(t) = (2.00 rad/s2) t + (1.00 rad/s4) t3. (a) Through how many radians does the wheel turn during the first 2.00 s of its motion? (b) Wh ...

A thin film 10 mm thick coat of fresh paint has just been

A thin film, 1.0 mm thick, coat of fresh paint has just been sprayed over a 1.5 m by 1.5 m square steel body part, which approximates a flat surface. The paint contains benzene as the solvent. The paint surface exerts a ...

Bullets of mass22g are fired in parallel paths with speeds

Bullets of mass2.2g are fired in parallel paths with speeds of216m/s through a hole2.0mm in diameter. How far from the hole must you be to detect a1.4cm diameter spread in the beam of bullets?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro