Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Q1. Two balls are hung from the cords. The first ball, of mass 1.5 kg, is pulled to the side and discharged, reaching a speed of 2.1 m/s at the bottom of its arc. Then, it hits and sticks to the other ball. The speed of the pair just after the collision is 1.5 m/s.

Determine the mass of second ball?

Q2. A block slides down a smooth ramp, beginning from rest at a height h. When it reaches the bottom it’s moving at speed Vi. It then persists to slide up the second smooth ramp.

At what height is its speed equivalent to Vi/2?

Q3. On a frictionless horizontal air table, puck A (with mass 0.255 kg ) is moving toward the puck B (with mass 0.369 kg ), that is initially at rest. After the collision, puck A has a velocity of 0.118 m/s to the left, and puck B has a velocity of 0.651 m/s to the right.

a) Determine the speed of puck A before the collision?

b) Compute Δk, the change in the total kinetic energy of the system which takes place during the collision.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M99821

Have any Question? 


Related Questions in Physics

A cat chases a mouse across a 16 m high table the mouse

A cat chases a mouse across a 1.6 m high table. The mouse steps out of the way, and the cat slides off the table and strikes the floor 1.1 m from the edge of the table. What was the cat's speed when it slid off the table ...

A youre using a 20-cm-focal-length convex lens to image a

(a) You're using a 20-cm-focal-length convex lens to image a small light bulb. Where should you place the bulb to get a half-size real image?  (b) A movie projector uses a single lens to project a real image on a screen ...

The gravitational attraction f between the earth and a

The gravitational attraction, F, between the earth and a satellite of mass m at a distance r from the center of the earth is given by where M is the mass of the earth, and G is a constant. Find the rate of change of forc ...

Astudent builds a110m long beam that rotates about an axis

Astudent builds a11.0m long beam that rotates about an axis at one end (see figure below). Its moment of inertia is 3540 kg.m2. When the studentapplies a forceFto the other end of the beam,the beam's angular acceleration ...

Determine the value of henrys law constant in pakgm3 of

Determine the value of Henry's law constant, in Pa/(kg/m 3 ) of chlorine for the chlorine-water system. The following equilibrium data at 293 K were reported in the Chemical Engineering Handbook.

F every transmitted packet were created by adding together

f every transmitted packet were created by adding together source packets at random with probability 1/2 of each source packet's being included, show that the probability that K' = K received packets suffice for the opti ...

How does period depend on amplitude of the oscillation

How does period depend on amplitude of the oscillation? Specifically, do you think bigger-amplitude motion takes more time, less time, or the same amount of time as smaller-amplitude motion?

You launch a model rocket from ground level it moves

You launch a model rocket from ground level. It moves directly upward with a constant acceleration of 77.5 m/s2 for 1.10 seconds, at which point it runs out of fuel. Assuming air resistance on the rocket is negligible, w ...

The technique of interleaving which allows bursts of errors

The technique of interleaving, which allows bursts of errors to be treated as independent, is widely used, but is theoretically a poor way to protect data against burst errors, in terms of the amount of redundancy requir ...

1 describe the partial equilibrium conditions of a piece of

1. Describe the partial equilibrium conditions of a piece of Si sitting on top a desk in a room at a space-time constant temperature of 300K. 2. A piece of pure silicon is immersed in pure boiling water. What are the ess ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen