Can illuminators be computer controlledpractically all can, Ask an Expert

Academics

Can illuminators be computer controlled?

Practically all can be computer controlled as well as illuminators are not an exception. Color discs, mechanical shutters and lamp voltage, in the case of gas discharge lamps, all can be controlled and programmed with a computer.

This is usually offered as an option on most illuminators, by using DMX control and step motors.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9555910

Have any Question?Write your Review or question?

Related Questions in Physics

Question if a proton moved from a location with a 50v

Question: If a proton moved from a location with a 5.0V potential to a location with 7.5V potentia, would its potential energy increase or decrease? If an electron moved from a location with 7.5V potential to a location ...

Question three odd-shaped blocks of chocolate have the

Question: Three odd-shaped blocks of chocolate have the following masses and center-of-mass coordinates: (1) 0.300kg , (0.300 m, 0.300 m); (2) 0.400kg , (0.200 m, -0.400 m); (3) 0.200 kg , (-0.300m , 0.600 m). Find the x ...

Question a soap bubble is essentially a thin film of water

Question: A soap bubble is essentially a thin film of water surrounded by air. The colors you see in soap bubbles are produced by interference. What visible wavelengths of light are strongly reflected from a 390 nm -thic ...

Question a physics student on planet exidor throws a ball

Question: A physics student on Planet Exidor throws a ball, and it follows the parabolic trajectory shown in the figure. The ball's position is shown at 1.0 s intervals until t = 3.0 s. At t = 1.0 s, the ball's velocity ...

Question a single loop of wire with an area of

question: A single loop of wire with an area of 9.03Ã-10-2 m^2 is in a uniform magnetic field that has an initial value of 3.66 T, is perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.199 ...

Qustion a pendulum is made by tying a 590 g ball to a 45

Qustion: A pendulum is made by tying a 590 g ball to a 45 cm-long string. The pendulum is pulled 22o to one side, then released. Part A: What is the ball's speed at the lowest point of its trajectory? Part B: To what ang ...

Question a solid sphere and a solid disk of the same mass

Question: A solid sphere and a solid disk of the same mass and radius are rolling wihtout slipping at the same speed. A. What is the ration of their kinetic energies? B. What is the ratio of their angular momenta (measur ...

Question a projectile is fired with an initial speed of

Question: A projectile is fired with an initial speed of 49.6m/s at an angle of 41.2 degrees above the horizontal on a long flat firing range. A) Determine the maximum height reached by the projectile. B) Determine the t ...

Question the starter motor of a car engine draws a current

Question: The starter motor of a car engine draws a current of 170 A from the battery. The copper wire to the motor is 5.80 mm in diameter and 1.2 m long. The starter motor runs for 0.670 s until the car engine starts. A ...

What is the average acceleration of a vehicle which speeds

What is the (average) acceleration of a vehicle which speeds up from 22 m/s to 88 m/s in 21.2 seconds? please provide work to explain

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert