Calibration standards.transfer 1.00 5.00 10.00 15.00 and, Ask an Expert

Academics

Calibration standards.Transfer 1.00, 5.00, 10.00, 15.00 and 20.00 mL aliquots of 10ppm F- solution to 100 mL flasks. Add 50 mL of TISAB containing CDTA to each. Dilute to the mark with DI water and mix thoroughly. Calculate the exact concentration of F- in each calibration standard.

So what would the calculations set up and answers be to find the concentration of F- in each standard.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9454905

Have any Question?Write your Review or question?

Related Questions in Chemistry

The molecular weight of an unknown gas was measured by an

The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?

You are required to read the following case study and

You are required to read the following case study and prepare a Project Feasibility Study and Timeline based on the information contained in the case study. Residential Duplex Development Project You own a real estate ...

An analysis of an oxide of nitrogen with a molecular weight

An analysis of an oxide of nitrogen with a molecular weight of92.02 amu gave 69.57% oxygen and 30.43 % nitrogen. What is the empirical formula of the compound?

A 41 kg person walking 56 kmhr requires 758 kj of energy

A 41 kg person walking 5.6 km/hr requires 758 kJ of energy per hour. How much further does he have to walk to consume the addition energy contained i 320 g of ground beef relative to 320 g of broiled chicken? The energy ...

What are the symbol and name of the element whose average

What are the symbol and name of the element whose average atoms have a mass very nearly half the mass of an average silicon atom?

Over the next 12 months bradley metals located in vancouver

Over the next 12 months Bradley Metals (Located in Vancouver) will order aprox. 6000 of forging units (from Kurrat Tools, located in Montreal) with the average weight of 15 LBS/unit.(6000/12= 500 units per month). 6,00 ...

To standardize a solution of naoh one uses a primary

To standardize a solution of NaOH, one uses a primary standard called potassium hydrogen phthalate (KHP for short). It is a monoprotic acid that can be obtained extremely pure and dried to a constant weigh out 0.556g of ...

Suppose a tank is filled with a2g so that initial pressure

Suppose a tank is filled with A2(g) so that initial pressure is 0.8688 atm at temperature of 298K. Some of the A2(g) dissociates and when the system reaches equlibrium the total pressure in the tank is 1.275 atm. Calcula ...

Upon decomposition one sample of magnesium fluoride

Upon decomposition, one sample of magnesium fluoride produced 2.55 kg of magnesium and 3.99kg of fluorine. A second sample produced 1.40 kg of magnesium. How much fluorine (in grams) did the second sample produce?

If liquid is at or above its flash point the flame spread

If liquid is at or above it's flash point, the flame spread rate is fast, and the entire pool is engulfed within seconds. In such a case, the liquid is already evaporating sufficiently to reach the lower flammability lim ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert