Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Calculating the weight percent austenite and weight percent proeutectoid ferrite in hypoeutctoid plain carbon steel

A 0.65 percent C hypoeutctoid plain carbon steel is slowly cooled from about 950°C to a temperature just slightly above 723°C. Compute the weight percent austenite and weight percent proeutectoid ferrite in this steel.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917082

Have any Question? 


Related Questions in Physics

Explain the very large generation rate obtained in the

Explain the very large generation rate obtained in the first part of problem 1. How many electron-hole pairs are created by an electron passing through a layer of 1μm thick at the scattering limited velocity? Problem 1 H ...

If the a1n-si schottky barrier contact shown in given

If the A1/n-Si Schottky barrier contact shown in given Figure was used as the ohmic contact to the n-Si surface of the 1957SNS p+/n diode, how would the forward I-V characteristics look? Sketch it both on linear-linear a ...

1 what evidence does a correct casting-out-nines match give

1. What evidence does a correct casting-out-nines match give in favour of the hypothesis that the addition has been done correctly? 2. What is the probability of a false negative, i.e., the probability, given that the tw ...

A cat chases a mouse across a 16 m high table the mouse

A cat chases a mouse across a 1.6 m high table. The mouse steps out of the way, and the cat slides off the table and strikes the floor 1.1 m from the edge of the table. What was the cat's speed when it slid off the table ...

What is a group of like-minded individuals called that

What is a group of like-minded individuals called that shares a similar sensibility and enjoys cultural products in similar ways? (please explain)

A ideal transformer has 50 turns in its primary and 250

A ideal transformer has 50 turns in its primary and 250 turns in its secondary. a) Calculate the voltage in the secondary if 12 V DC is connected to primary b) Calculate the voltage in the secondary if 12V AC is connecte ...

A process is being developed to produce carbonated

A process is being developed to produce carbonated beverages. As part of this process, a wetted-wall absorption column of 2.0 m length will be used to dissolve carbon dioxide, CO 2 , gas into water. Pure mountain spring ...

The wetted-well column shown in figure 304 is used to

The wetted-well column shown in Figure 30.4 is used to humidify a pressurized air stream. Bone-dry air (containing no water vapor) at 2.0 atm and 27°C is introduced to the bottom of the column at a volumetric flow rate o ...

In the aeration of wastewater liquid-gas contact systems

In the aeration of wastewater, liquid-gas contact systems are designed to raise the concentration toward equilibrium levels. This goal is accomplished by dispersing air bubbles into the water. An aqueous solution, initia ...

A ball is tossed into the air from a bridge and its height

A ball is tossed into the air from a bridge, and its height, y (in feet), above the ground t seconds after it is thrown is given by (a) How high above the ground is the bridge? (b) What is the average velocity of the bal ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen