Calculate the terminal velocity of a 10 cm bug assume that, Ask an Expert

Academics

Calculate the terminal velocity of a 1.0 cm bug. Assume that the density of the bug is 1.0 g/cm^3.and the bug is spherical in shape with a diameter of 1.0 cm. Assume further that the area of the bug subject to air friction is πr^2.(the coefficient of air friction is 0.88).

IF the bug falls from a height of 200 m find the speed with which the bug hits the ground if there is no air resistance.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91021248

Have any Question?Write your Review or question?

Related Questions in Physics

Question standing waves on a wire are described by

Question: Standing waves on a wire are described by y(x,t)=(ASWsinkx)sin?t, with ASW = 3.00mm , ? = 975rad/s , and k = 0.790?rad/m . The left end of the wire is at x = 0. Part A: At what distances from the left end are t ...

Question pennies today are copper-covered zinc but older

Question: Pennies today are copper-covered zinc, but older pennies are 3.1 g of solid copper. What are the total positive charge and total negative charge in a solid copper penny that is electrically neutral?The density ...

Part a find leslies average speed when she runs to the

PART A: Find Leslie's average speed when she runs to the store 14 km away in 24 min Express your answer to two significant figures and include the appropriate units. PART B: How fast is this in m/s? Express your answer t ...

Question a somewhat idealized graph of the speed of the

Question: A somewhat idealized graph of the speed of the blood in the ascending aorta during one beat of the heart appears as in the figure Part A: Approximately how far, in cm, does the blood move during one beat? Part ...

Question a particle leaves the origin with an initial

Question: A particle leaves the origin with an initial velocity v = (3.00 i hat) m/s and a constant acceleration a = (-3.00 i hat - 1.400 j hat) m/s2 (a) What is the velocity of the particle when it reaches its maximum x ...

Question a plastic rod is charged to -20 by rubbinga have

Question: A plastic rod is charged to -20 by rubbing. a. Have electrons been added to the rod or protons removed? Explain. b. How many electrons have been added or protons removed? The response must be typed, single spac ...

Question the starter motor of a car engine draws a current

Question: The starter motor of a car engine draws a current of 170 A from the battery. The copper wire to the motor is 5.80 mm in diameter and 1.2 m long. The starter motor runs for 0.670 s until the car engine starts. A ...

Question a sump pump is draining a flooded basement at the

Question: A sump pump is draining a flooded basement at the rate of 0.650 L/s, with an output pressure of 2.00 ? 10 5 N/m 2 . Neglect frictional losses in both parts of this problem. (a) The water enters a hose with a 3 ...

A high-speed train is built to be 600 m long the train is

A high-speed train is built to be 600 m long. The train is passing through a 500 m long tunnel. a. At what speed, according to an observer on the ground, the train will be just completely covered by the tunnel at one ins ...

Question a soap bubble is essentially a thin film of water

Question: A soap bubble is essentially a thin film of water surrounded by air. The colors you see in soap bubbles are produced by interference. What visible wavelengths of light are strongly reflected from a 390 nm -thic ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert