An electric motor rotating a workshop grinding wheel at a, Ask an Expert

Academics

An electric motor rotating a workshop grinding wheel at a rate of 9.70 101 rev/min is switched off. Assume the wheel has a constant negative angular acceleration of magnitude 1.60 rad/s2.

(a) How long does it take for the grinding wheel to stop?

______ s

(b) Through how many radians has the wheel turned during the interval found in (a)?

______ rad

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91034426

Have any Question?Write your Review or question?

Related Questions in Physics

Question a parallel-plate air capacitor has a capacitance

Question: A parallel-plate air capacitor has a capacitance of 920 pF. The charge on each plate is 2.55 ÂµC. (a) What is the potential difference between the plates? (b) If the charge is kept constant, what will be the po ...

Question a point charge q1 is held stationary at the origin

Question: A point charge q1 is held stationary at the origin. A second charge q2 is placed at point a, and the electric potential energy of the pair of charges is 5.4 x 10^-8J. When the second charge is moved to point b, ...

Question pluto moves in a fairly elliptical orbit around

Question: Pluto moves in a fairly elliptical orbit around the sun. Pluto's speed at its closest approach of 4.43 *10^9 km is 6.12 km/s. What is Pluto's speed at the most distant point in its orbit, where it is 7.30 *10^9 ...

Question in a physics laboratory experiment a coil with 180

Question: In a physics laboratory experiment, a coil with 180 turns enclosing an area of 13.5 cm^2 is rotated during the time interval 5.00Ã-10-2 s from a position in which its plane is perpendicular to Earth's magnetic ...

Question a slide projector needs to create a 84 cm high

Question: A slide projector needs to create a 84 cm high image of a 2.0 cm tall slide. The screen is 240 cm from the slide. Assume that it is a thin lens. (a) What focal length does the lens need? cm (b) How far should y ...

Question a standard biological microscope is required to

Question: A standard biological microscope is required to have a magnification of 200Ã-. When paired with a 10Ã- eyepiece, what power objective is needed to get this magnification? Part A: Assume that the length of the t ...

After deploying her parachute a skydiver falls through the

After deploying her parachute, a skydiver falls through the air with a constant speed of 8.00 m/s . As she falls, there is a constant breeze blowing west at 2.50 m/s. At what angle from the downward vertical does the par ...

Question at one point in a pipeline the waters speed is 300

Question: At one point in a pipeline the water's speed is 3.00 m/s and the gauge pressure is 5.00 x 10 4 Pa. Find the gauge pressure at a second point in the line, 11.0 m lower than the first, if the pipe diameter at the ...

Question a particle leaves the origin with an initial

Question: A particle leaves the origin with an initial velocity v = (3.00 i hat) m/s and a constant acceleration a = (-3.00 i hat - 1.400 j hat) m/s2 (a) What is the velocity of the particle when it reaches its maximum x ...

A ski jumper leaves the ski track moving in the horizontal

A ski jumper leaves the ski track moving in the horizontal direction with a speed of 15.0 m/s. The landing incline below her falls off with a slope of 45.0 degrees. Where does she land on the incline?

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert