An aluminum rod of length l has a resistance of 8 ohms half, Ask an Expert

Academics

An aluminum rod of length l has a resistance of .8 ohms. Half of the rod is machined down so that half of the rod now has half of the radius of the original radius. What will be the new resistance? If it helps the resistivity of aluminum is 2.82*(10^-8) ohm meters.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9909953

Have any Question?Write your Review or question?

Related Questions in Physics

Question a radar station locates a sinking ship at range

Question: A radar station locates a sinking ship at range 17.9 km and bearing 136Â° clockwise from north. From the same station, a rescue plane is at horizontal range 19.6 km, 156Â° clockwise from north, with elevation 2 ...

Question to take off from the ground an airplane must reach

Question: To take off from the ground, an airplane must reach a sufficiently high speed. The velocity required for the takeoff, the takeoff velocity, depends on several factors, including the weight of the aircraft and t ...

Propane boilers are a common technology for domestic

Propane boilers are a common technology for domestic heating, and have a typical energy efficiency of 90%. The chemical formula of propane is C 3 H 8 , its lower heating value is 50,400 kJ/kg, and its carbon content by m ...

Problem here we ponder a few issues related to

Problem: Here we ponder a few issues related to thermodynamic reversihilityfirrerversihility. Recall that a process is said to be thermodynamically reversible if and only if there exists an e?ecing process. That can retu ...

A car accelerates down a hill going from the rest to 300 ms

A car accelerates down a hill, going from the rest to 30.0 m/s in 6.00 s. A toy inside the car hangs by a string from the car's ceiling. The ball in the figure represents the toy, of the mass 0.200 kg. The acceleration u ...

An object falls because of gravity at a rate of -980 cms2 -

An object falls because of gravity at a rate of -980 cm/s2 (- sign is indicative of a downward direction) for 10. seconds. If it starts from rest (vo = 0) and its position starts from do= 0.0, where is it 10. seconds lat ...

Question a slide projector needs to create a 84 cm high

Question: A slide projector needs to create a 84 cm high image of a 2.0 cm tall slide. The screen is 240 cm from the slide. Assume that it is a thin lens. (a) What focal length does the lens need? cm (b) How far should y ...

Question suppose you have a block resting on a horizontal

Question: Suppose you have a block resting on a horizontal smooth surface. the block (mass m) is attached to a horizontak spring (spring constant k) which is fixed at one end. the mass is pulled to one side and released. ...

Suppose the convention were adopted that defines w and w 0

Suppose the convention were adopted that defines W and W 0 in the first law of thermodynamics to be the "work done on the system by the surroundings." a. Write the first law with this alternate convention. b. Why do the ...

1 evaluate 50000 107380 10-16 report 2 decimals for

1) Evaluate (5.0000 * 10^7)(3.80 * 10^-16). Report 2 decimals for result 2) 1,400 kg car moving at 7.0 m/s is stopped by action of it braces. The work done by the car braces is .....Joules. Response in 2 decimals. 3) The ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert