Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Find the time constant for a spring-mass system.

A spring with spring constant 18N/m hangs from the ceiling. A 580g ball is attached to the spring and allowed to come to rest. It is after that pulled down 8 cm and released.

What is the time constant if the ball's amplitude has decreased to 2.20cm after 51 oscillations?

Physics, Academics

  • Category:- Physics
  • Reference No.:- M918012

Have any Question? 


Related Questions in Physics

Estimate how many patterns in ay are recognizable as the

Estimate how many patterns in AY are recognizable as the character ‘2'. [The aim of this problem is to try to demonstrate the existence of as many patterns as possible that are recognizable as 2s.] Discuss how one might ...

The three cardsa one card is white on both faces one is

The three cards (a) One card is white on both faces; one is black on both faces; and one is white on one side and black on the other. The three cards are shuffled and their orientations randomized. One card is drawn and ...

1 the population of the ukraine fell from 457 million in

1. The population of the Ukraine fell from 45.7 million in 2009 to 45.42 million in 2010.40 Assuming exponential decline, in what year is the population predicted to be 45 million? 2. Find the half-life of a radioactive ...

A using a calculator or computer sketch the graph of y 2ex

(a) Using a calculator or computer, sketch the graph of y = 2ex + 5e-x for -3 ≤ x ≤ 3, 0 ≤ y ≤ 20. Observe that it looks like the graph of y = cosh x. Approximately where is its minimum? (b) Show algebraically that y = 2 ...

1 give a simple reason based on device physics or charge

1. Give a simple reason based on device physics or charge store concept to show that the speed up of the recovery during switch-off transient is given by the ratio, J F /J R . Afterwards, show this also mathematically us ...

1 describe the partial equilibrium conditions of a piece of

1. Describe the partial equilibrium conditions of a piece of Si sitting on top a desk in a room at a space-time constant temperature of 300K. 2. A piece of pure silicon is immersed in pure boiling water. What are the ess ...

1 a pressure of 10 mpa is applied to 025 m3nbspof a liquid

1. A pressure of 10 MPa is applied to 0.25 m 3  of a liquid, causing a volume reduction of 0.005 m 3 . Determine the bulk modulus of elasticity. 2. The bulk modulus of elasticity for water is 2.205 GPa. Determine the cha ...

A flat steel plate is 20 m length and 20 m width initially

A flat steel plate is 2.0 m length and 2.0 m width initially contains a very thin coating of lubricating oil used in a manufacturing process. An engineer is considering the feasibility of using hot forced air convection ...

Figure 350 shows the tangent line approximation to fx near

Figure 3.50 shows the tangent line approximation to f(x) near x = a. (a) Find a, f(a), f'(a). (b) Estimate f(2.1) and f(1.98). Are these under- or overestimates? Which estimate would you expect to be more accurate and wh ...

A cat chases a mouse across a 16 m high table the mouse

A cat chases a mouse across a 1.6 m high table. The mouse steps out of the way, and the cat slides off the table and strikes the floor 1.1 m from the edge of the table. What was the cat's speed when it slid off the table ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro