A slab of a thermal insulator with a cross-sectional area, Ask an Expert

Academics

A slab of a thermal insulator with a cross-sectional area of 110{\rm cm^2} is 2.90{\rm cm} thick.

Part A Its thermal conductivity is 7.50×10?2 {\rm W/(m \K)} ; If the temperature difference between opposite faces is 78.5^\circ C, how much heat flows through the slab in 1 day?

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9863492

Have any Question?Write your Review or question?

Related Questions in Physics

Fire behavior and combustionwhen pump operators apply

Fire Behavior and Combustion. When pump operators apply pressure to water in pre-connect hose lines there is a limit on the amount of water and velocity at which the water will travel through the hose lines. This is refe ...

Question the siren of a fire engine that is driving

Question: The siren of a fire engine that is driving northward at 31.0 m/s emits a sound of frequency 2020 Hz. A truck in front of this fire engine is moving northward at 19.0 m/s. a) What is the frequency of the siren's ...

Question part a find the energy u0 stored in the capacitor

Question: Part A: Find the energy U0 stored in the capacitor. Express your answer in terms of A, d, V, and Ïµ0. Remember to enter Ïµ0 as epsilon_0. Part B: The capacitor is now disconnected from the battery, and the plat ...

Question a small block is attached to an ideal spring and

Question: A small block is attached to an ideal spring and is moving in SHM on a horizontal, frictionless surface. The amplitude of the motion is 0.300mand the period is 3.39s . Part A: What is the acceleration of the bl ...

Question a satellite orbiting the moon very near the

Question: A satellite orbiting the moon very near the surface has a period of 110 min, What is free-fall acceleration on the surface of the moon? The response must be typed, single spaced, must be in times new roman font ...

Question one type of bb gun uses a spring-driven plunger to

Question: One type of BB gun uses a spring-driven plunger to blow the BB from its barrel. (a) Calculate the force constant of its plunger's spring if you must compress it 0.130 m to drive the 0.0580-kg plunger to a top s ...

Initially at time t 0 a particle is moving vertically at 5

Initially (at time t = 0) a particle is moving vertically at 5 m/s and horizontally at 0 m/s. Its horizontal acceleration is 1.6 m/s2. At what time will the particle be traveling at 57? with respect to the horizontal? Th ...

Question a person stands on a scale in an elevator as the

Question: A person stands on a scale in an elevator. As the elevator starts, the scale has a constant reading of 584 N. As the elevator later stops, the scale reading is 398 N. Assume the magnitude of the acceleration is ...

Problem an athlete performing a long jump leaves the ground

Problem: An athlete performing a long jump leaves the ground at a 28.2 degree angle and lands 7.67 m away. A) What was the takeoff speed? B) If this speed were increased by just 5.0%, how much longer would the jump be?

Question a pendulum is made by tying a 520g ball to a 460cm

Question: A pendulum is made by tying a 520g ball to a 46.0cm -long string. The pendulum is pulled 21.0?to one side, then released. A) What is the ball's speed at the lowest point of its trajectory? B) To what angle does ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert