A sample with an unknown quantity of an analyte with a, Ask an Expert

Academics

A sample with an unknown quantity of an analyte with a molecular mass of 71.24g/mol was dissolved in 250mL of ethanol. Then 5.0mL was withdrawn and diluted to 200mL. The spectrum of this solution exhibited a maximum absorbance of 0.642 units at 554nm in a 2cm cell. The molecular absorbance , e, is 423 M-1cm-1. What is the mass of the analyte in grams?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9874191

Have any Question?Write your Review or question?

Related Questions in Chemistry

A power plant converts the heat energy in coal to

A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...

The molecular weight of an unknown gas was measured by an

The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?

If liquid is at or above its flash point the flame spread

If liquid is at or above it's flash point, the flame spread rate is fast, and the entire pool is engulfed within seconds. In such a case, the liquid is already evaporating sufficiently to reach the lower flammability lim ...

To standardize a solution of naoh one uses a primary

To standardize a solution of NaOH, one uses a primary standard called potassium hydrogen phthalate (KHP for short). It is a monoprotic acid that can be obtained extremely pure and dried to a constant weigh out 0.556g of ...

A decompression chamber used by deep-sea dives has a volume

A decompression chamber used by deep-sea dives has a volume of 10.3 m 3 and operates at an internal pressure of4.5atm. What volume, in m 3 would the air in the chamber occupy if it were at 1 atm pressure, assuming no t ...

0394 mol of a solid was dissolved in 340 ml of water at 269

0.394 mol of a solid was dissolved in 340 mL of water at 26.9 oC. After the solid had fully dissolved, the final temperature of the solution was 31.6 oC. What is the molar heat of solution of the substance?

What would be the effect on our body chemistry if large

What would be the effect on our body chemistry if large numbers of enzymes were to become malformed and how do they become malformed?

Insoluble pbbr2snbspnbspprecipitates when solutions of

Insoluble PbBr2(s) precipitates when solutions of Pb(NO3)2(aq) and NaBr(aq) are mixed. Pb(NO3)2(aq) + 2NaBr(aq) ---> PbBr2(s) + 2NaNO3(aq) ΔrH = ? To measure the enthalpy change, 350. mL of 0.50 M Pb(NO3)2(aq) and 350. ...

What is an example of a cell diagram for a voltaic cell how

What is an example of a cell diagram for a voltaic cell? How do I calculate the standard cell potential for the example of the voltaic cell?

A paint contains 1800 ppm lead approximately what mass of

A paint contains 180.0 ppm lead. Approximately what mass of lead will be in 1.00 cm ^3 of this paint when 1.00 gal is uniformly applied to 445.0 ft 2 of a wall. The density of the paint is 8.00 lb/gal.

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert