A proton m1.67x10-27 kg is being accelerated along a, Ask an Expert

Academics

Q. A proton (m=1.67x10-27 kg) is being accelerated along a straight line at 3.6*10^5 m/sec2 in a machine. If the proton has an initial speed of 2.4x10^7 m/sec.

what is the final velocity after travelling for 2 sec?

What is the increase in its kinetic energy?

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9348120

Have any Question?Write your Review or question?

Related Questions in Physics

Additional problem 1unpolarized light passes through two

ADDITIONAL PROBLEM 1 Unpolarized light passes through two polarizers whose transmission axes are at an angle # with respect to each other. What should be the angle # between the transmission axes of the polarizers if it ...

Question a skier is accelerating down a 300 degree hill at

Question: A skier is accelerating down a 30.0 degree hill at 1.80 m/s2. What is the vertical component of her acceleration? How long will it take her to reach the bottom of the hill, assuming she starts from rest and acc ...

Fire behavior and combustionwhen pump operators apply

Fire Behavior and Combustion. When pump operators apply pressure to water in pre-connect hose lines there is a limit on the amount of water and velocity at which the water will travel through the hose lines. This is refe ...

Question rotational kinetic energy and conservation of

Question: Rotational Kinetic Energy and Conservation of Energy Ranking Task The five objects of various masses, each denoted m, all have the same radius. They are all rolling at the same speed as they approach a curved i ...

Problem a jet airplane with a 750 m wingspan is flying at

Problem: A jet airplane with a 75.0 m wingspan is flying at 265 m/s. Part (a) What emf is induced between the wing tips in V if the vertical component of the Earth. The response must be typed, single spaced, must be in t ...

Question a point charge with charge q1 is held stationary

Question: A point charge with charge q1 is held stationary at the origin. A second point charge with charge q2moves from the point (x1, 0) to the point (x2, y2). Please use k for Coulomb's constant rather than writing it ...

Question a series rlc circuit consists of a 50ohm resistor

Question: A series RLC circuit consists of a 50ohm resistor, a 3.3 mH inductor, and a 480 nF capacitor. It is connected to a 5.0 kHz oscillator with a peak voltage of 5.0 V. A) What is the instantaneous current i when e= ...

Question a point charge q1 400 nc is placed at the origin

Question: A point charge q1 = 4.00 nC is placed at the origin, and a second point charge q2 = -3.05 nC is placed on the x-axis at x = 21.0 cm. A third point charge q3 = 1.90 nC is to be placed on the x-axis between q1 an ...

Question sams job at the amusement park is to slow down and

Question: Sam's job at the amusement park is to slow down and bring to a stop the boats in the log ride. If a boat and its riders have a mass of 800kg and the boat drifts in at 1.4m/s how much work does Sam do to stop it ...

Question a sled and rider gliding over horizontal

Question: A sled and rider, gliding over horizontal, frictionless ice at 5.8 m/s, have a combined mass of 86 kg. The sled then slides over a rough spot in the ice, slowing down to 3.0 m/s. What impulse was delivered to t ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert