A piston of cross-section area is used in hydraulic, Ask an Expert

Academics

A piston of cross-section area is used in hydraulic pressure to exert a small force of magnitude on the enclosed liquid. A pipe connected leads to a larger piston of cross-section area A.

If 4.36 centimeter is the diameters of the piston, determine force magnitude on the small piston will balance a 28.2kN force on the large piston?

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91189729

Have any Question?Write your Review or question?

Related Questions in Physics

Question a superball with mass m equal to 50 grams is

Question: A superball with mass m equal to 50 grams is dropped from a height of hi = 1.5 m . It collides with a table, then bounces up to a height of hf= 1.0m. The duration of the collision (the time during which the sup ...

Question part a what magnitude of force must the worker

Question: Part A: What magnitude of force must the worker apply to move the crate at constant velocity? Express your answer using two significant figures. Part B: How much work is done on the crate by this force when the ...

Question suppose the free-fall acceleration at some

Question: Suppose the free-fall acceleration at some location on earth was exactly 9.8000 m/s^2. What would it be at the top of a 1000 -tall tower at this location? The response must be typed, single spaced, must be in t ...

Question the starter motor of a car engine draws a current

Question: The starter motor of a car engine draws a current of 170 A from the battery. The copper wire to the motor is 5.80 mm in diameter and 1.2 m long. The starter motor runs for 0.670 s until the car engine starts. A ...

Question to take off from the ground an airplane must reach

Question: To take off from the ground, an airplane must reach a sufficiently high speed. The velocity required for the takeoff, the takeoff velocity, depends on several factors, including the weight of the aircraft and t ...

Question standing waves on a wire are described by

Question: Standing waves on a wire are described by y(x,t)=(ASWsinkx)sin?t, with ASW = 3.00mm , ? = 975rad/s , and k = 0.790?rad/m . The left end of the wire is at x = 0. Part A: At what distances from the left end are t ...

Question a point charge of magnitude q is at the center of

Question: A point charge of magnitude q is at the center of a cube with sides of length L. a) What is the electric flux through each of the six faces of the cube? b) What would be the flux through a face of the cube if i ...

Question starting from rest a computer disk drive is turned

Question: Starting from rest, a computer disk drive is turned on and has constant angular acceleration. If it takes 0.9s for the drive to make it's second complete revolution, find the following: a) How long did it take ...

Question storm clouds build up large negative charges as

Question: Storm clouds build up large negative charges, as described in the chapter. The charges dwell in charge centers, regions of concentrated charge. Suppose a cloud has -25 C in a 1.0-km-diameter spherical charge ce ...

Question a 300kg- box is being pulled across a carpeted

Question: A 30.0kg- box is being pulled across a carpeted floor by a horizontal force of 230N, against a friction force of 210N. What is the acceleration of the box? How far would the box move in 3s, if it starts from re ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert