A parallel-plate capacitor is to be constructed by using as, Ask an Expert

Academics

A parallel-plate capacitor is to be constructed by using, as a dielectric, rubber with a dielectric constant of 3.20 and a dielectric strength of 25.0MV/m. The capacitor is to have a capacitance of 1.70nFand must be able to withstand a maximum potential difference of 5.00kV.

What is the minimum area the plates of this capacitor can have?

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91065463

Have any Question?Write your Review or question?

Related Questions in Physics

A 00260 kg bullet moving horizontally at 400 ms embeds

A 0.0260 kg bullet moving horizontally at 400 m/s embeds itself into an initially stationary 0.500 kg block. What is their velocity just after the collision? The bullet-embedded block slides 8.0 m on a horizontal surface ...

Question an object of mass m is traveling on a horizontal

Question: An object of mass m is traveling on a horizontal surface. There is a coefficient of kinetic friction Âµ between the object and the surface. The object has speed v when it reaches x=0 and encounters a spring. Th ...

Questio a pump is required to lift a mass of 850 kg of

Questio: A pump is required to lift a mass of 850 kg of water per minute from a well of depth 13.8 m and eject it with a speed of 17.2 m/s. part A. How much work is done per minute in lifting the water? part B. How much ...

An inflatable life raft is released from an air plane at

An inflatable life raft is released from an air plane at 500 m altitude, in level flight, with an air speed of 20 m/s in the horizontal direction. How long before the raft strikes the water? How far from the release poin ...

Question a steel cable with mass is lifting a girder the

Question: A steel cable with mass is lifting a girder. The girder is speeding up. Part A Draw a free-body diagram for the steel cable. Draw the vectors starting at the black dots. The location and orientation of the vect ...

Question seat belts and air bags save lives by reducing the

Question: Seat belts and air bags save lives by reducing the forces exerted on the driver and passengers in an automobile collision. Cars are designed with a "crumple zone" in the front of the car. In the event of an imp ...

Quesiton a skydiver of mass m jumps from a hot air balloon

Quesiton: A skydiver of mass m jumps from a hot air balloon and falls a distance d before reaching a terminal velocity of magnitude v . Assume that the magnitude of the acceleration due to gravity is g . - What is the wo ...

Question the position of a mass oscillating on a spring is

Question: The position of a mass oscillating on a spring is given by x = (6.6cm) cos[2Ït/(0.69s)]. Part A: What is the frequency of this motion? Express your answer using two significant figures. Part B: When is the mas ...

Question the otto-cycle engine in a mercedes-benz slk230

Question: The Otto-cycle engine in a Mercedes-Benz SLK230 has a compression ratio of 8.8. A. What is the ideal efficiency of the engine? Use Î³=1.40. Express your answer using two significant figures. B. The engine in a ...

Question to take off from the ground an airplane must reach

Question: To take off from the ground, an airplane must reach a sufficiently high speed. The velocity required for the takeoff, the takeoff velocity, depends on several factors, including the weight of the aircraft and t ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert