Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Find a location to hang the third mass to balance the meter stick.

A meter stick supported at the 50 cm mark has masses of 300 g and 200 g hanging from it at the 10 cm and 60 cm mark, respectively. Where must we hang a third, 400 g mass to keep the meter stick balanced?

1. 0.30 m to the left of the point of support
2. 0.25 m to the right of the point of support.
3. 0.50 m above the point of support.
4. On the left end of the meter stick.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917332

Have any Question? 


Related Questions in Physics

Determine the mass transfer coefficient kc for the transfer

Determine the mass transfer coefficient, kc, for the transfer from a glucose sphere, 0.3 cm in diameter, which is sub merged in a 25°C aqueous stream flowing at a bulk velocity of 0.15 m/s. The mass diffusivity of glucos ...

Markov chain monte carlo methods do not compute partition

Markov chain Monte Carlo methods do not compute partition functions Z, yet they allow ratios of quantities like Z to be estimated. For example, consider a random-walk Metropolis algorithm in a state space where the energ ...

A thin film 10 mm thick coat of fresh paint has just been

A thin film, 1.0 mm thick, coat of fresh paint has just been sprayed over a 1.5 m by 1.5 m square steel body part, which approximates a flat surface. The paint contains benzene as the solvent. The paint surface exerts a ...

Calculate the macroscopic thermal neutron absorption cross

Calculate the macroscopic thermal neutron absorption cross section for natural uranium. (ignore the trace amounts of234U; the a/o of235U in natural uranium is .72, and the a/o of the238U is .9928) Calculate the macroscop ...

The distance s a car has traveled on a trip is shown in the

The distance, s, a car has traveled on a trip is shown in the table as a function of the time, t, since the trip started. Find the average velocity between t = 2 and t = 5.

How many bits are needed to specify a selection of k

How many bits are needed to specify a selection of K objects from N objects? (N and K are assumed to be known and the selection of K objects is unordered.) How might such a selection be made at random without being waste ...

It is desired to recover hexane vapor from air using an

It is desired to recover hexane vapor from air using an absorption process. The absorption solvent is a nonvolatile mineral oil, which has a mass density of 0:80 g/cm 3  and a molecular weight of 180 g/g mole. In the dil ...

The moment just after the battery is turned on what is the

The moment just after the battery is turned on, what is the voltage across the resistor, the inductor, and the capacitor each? What is the current in the circuit? Explain your reasoning.

An oscillating mass at the end of a spring is at a distance

An oscillating mass at the end of a spring is at a distance y from its equilibrium position given by The constant k measures the stiffness of the spring. (a) Find a time at which the mass is farthest from its equilibrium ...

The wetted-well column shown in figure 304 is used to

The wetted-well column shown in Figure 30.4 is used to humidify a pressurized air stream. Bone-dry air (containing no water vapor) at 2.0 atm and 27°C is introduced to the bottom of the column at a volumetric flow rate o ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro