Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Q1. A material which consists of a Young’s modulus of elasticity of 250 GN m2 and a poisons ratio of 0.32, compute:

a) The bulk modulus of material.

b) The shear modulus of material.

Q2.

a) describe the methods of categorizing polymeric materials.

b) Differentiate between addition and condensation polymerization and give specific illustrations of polymers synthesized by each method.

Q3.

a) Mention the two necessary constituent elements of the plain carbon steel?

b) What do you mean by cementite?

c) Illustrate the values of hardness for the ferrite and cementite. State your answers in the units of Brinell hardness number. Give some references for the sources of your answers.

d) How are the given properties of iron affected if carbon is alloyed with it?

Describe your answer with reference to the microstructure of the steel.

  • Hardness
  • Strength
  • Ductility

e) What percentage of carbon generates the strongest plain carbon steel?

Physics, Academics

  • Category:- Physics
  • Reference No.:- M99880

Have any Question? 


Related Questions in Physics

Since the 1950s the carbon dioxide concentration in the air

Since the 1950s, the carbon dioxide concentration in the air has been recorded at the Mauna Loa Observatory in Hawaii.4 A graph of this data is called the Keeling Curve, after Charles Keeling, who started recording the d ...

Refernbspto ch 1 to review the three major sociological

Refer  to Ch. 1 to review the three major sociological perspectives. Use  all three perspectives (functionalism, conflict and interactionism) to analyze one of the following issues: fraternities and sororities, social ne ...

1 show that it is possible to have a higher electron

1. Show that it is possible to have a higher electron conductivity than hole conductivity in a p-type Si. P-type is defined by P>N. This is again impractical and gives false impression for the same reason as above. 2. A ...

Is the standard binary representation for positive integers

Is the standard binary representation for positive integers (e.g. cb(5) = 101) a uniquely decodeable code? Design a binary code for the positive integers, i.e., a mapping from n ∈ {1, 2, 3, . . .} to c(n) ∈ {0, 1} +, tha ...

1 what is the probability of block error of the n k hamming

1. What is the probability of block error of the (N, K) Hamming code to leading order, when the code is used for a binary symmetric channel with noise density f? 2. Prove that there exist families of codes with ‘bad' dis ...

Visible light is incident on an oil film n 151 coating a

Visible light is incident on an oil film (n = 1.51) coating a puddle of water. What minimum oil thickness will maximize the reflection of each of these colors: blue (460 nm) and yellow (580 nm).

A distortion is observed in the experimental hfcv curve of

A distortion is observed in the experimental HFCV curve of the 100A-oxide p-MOSC in problem after it is stressed in a very high electric field (about V G =8V). The distortion is indicated by the non-equal voltage shifts ...

For a boat to float in a tidal bay the water must be at

For a boat to float in a tidal bay, the water must be at least 2.5 meters deep. The depth of water around the boat, d(t), in meters, where t is measured in hours since midnight, is (a) What is the period of the tides in ...

When a 275 kg fan having blades 185 cm long is turned off

When a 2.75 kg fan, having blades 18.5 cm long, is turned off, its angular speed decreases uniformly from 10.0 rad/s to 6.30 rad/s in 5.00 s. (a) What is the magnitude of the angular acceleration of the fan? (b) Through ...

A beam of light at a wavelength of 700 nm with a spectral

A beam of light at a wavelength of 700 nm with a spectral width of 5 nm and spectral irradiance of 1290 illuminates a area of 10 cm what voltage can this beam generate if converted to electricity?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro