A how many moles of sodium benzoate must be added to 25 l, Ask an Expert

Academics

a) How many moles of sodium benzoate must be added to 2.5 L of .15 M benzoic acid to form a buffer whose pH is 4.46? Assume the addition of sodium benzoate does not change the total volume of the solution.

b) If a strong base, say potassium hydroxide, was added to the buffer above what would happen to the pH and why?

c) If 120.0 mL of 1.3 M KOH is added to the buffer what would be the new pH.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91020428

Have any Question?Write your Review or question?

Related Questions in Chemistry

An aqueous solution has a normal boiling point of 1020degc

An aqueous solution has a normal boiling point of 102.0°C. What is the freezing point of this solution? For water K b is 0.51°C/ m and K f = 1.86°C/ m.

The atomic masses of lithium-6 759 and lithium-7 9241 are

The atomic masses of Lithium-6 (7.59%) and Lithium-7 (92.41%) are 6.0151 and 7.016 amu, respectively. Calculate the average atomic mass of chlorine. The percentages in parentheses denote the relative abundances.

Suppose 17 g of zinc is treated with 62 g of pure hydrogen

Suppose 1.7 g of zinc is treated with 6.2 g of pure hydrogen chloride. What is the maximum mass (in g) of hydrogen gas that can be produced?

As a distributor testa produce doesnt have direct contact

As a distributor, Testa Produce doesn't have direct contact with the public. How might the company go about alerting consumers to its "green" initiatives?

Q1 sodium metal is very active with water therefore

Q1. Sodium metal is very active with water. Therefore, determining the value of a block of sodium will be impossible by water displacement. On the other hand, the density of sodium metal can be found in the chemistry han ...

A power plant converts the heat energy in coal to

A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...

Use the simulator for the hydrogen atom Use the simulator for the hydrogen atom

Use the simulator for the hydrogen atom (https://phet.colorado.edu/en/simulation/hydrogen-atom) to estimate the energy needed to transfer one mole of electrons from the energy level n = 1 to the level n = 3.

Nitro glyerine is an explosive used by the mining industry

Nitro glyerine is an explosive used by the mining industry. It detonates according to the following equation: 4C 3 H 5 N 3 O 9 (l)→ 12CO 2 (g) + 6N 2 (g) +10H 2 O(g) + O 2 (g) What volume is occupied by the gases produce ...

The solubility of silver sulfate ag2so4 inwater has been

The solubility of silver sulfate, Ag2SO4, inwater has been determined to be 8.0 g/L. What is the solubility in0.37 M sodium sulfate,Na2SO4?

Wy is nh42cro4nbspa molecular compound if ionic is metal

Why is (NH 4 ) 2 CrO 4 a molecular compound if ionic is metal + nonmetal and molecular is nonmetal+nonmetal? The Cr is a metal and the NH4 and O4 are non metal so it is metal+non metal but why cant it be ionic instead o ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert