A calculate the force needed to bring a 1000 kg car to rest, Ask an Expert

Academics

(a) Calculate the force needed to bring a 1000 kg car to rest from a speed of 95.0 km/h in a distance of 115 m (a fairly typical distance for a nonpanic stop

(b) Suppose instead the car hits a concrete abutment at full speed and is brought to a stop in 2.00 m. Calculate the force exerted on the car and compare it with the force found in part (a), i.e. find the ratio of the force in part(b) to the force in part(a).

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9858730

Have any Question?Write your Review or question?

Related Questions in Physics

Question this problem concerns the properties of circular

Question: This problem concerns the properties of circular orbits for a satellite of mass m orbiting a planet of mass M in an almost circular orbit of radius r. In doing this problem, you are to assume that the planet ha ...

Question a solid sphere and a solid disk of the same mass

Question: A solid sphere and a solid disk of the same mass and radius are rolling wihtout slipping at the same speed. A. What is the ration of their kinetic energies? B. What is the ratio of their angular momenta (measur ...

Question a rock thrown with speed 120ms and launch angle

Question: A rock thrown with speed 12.0m/s and launch angle 30.0 degrees (above the horizontal) travels a horizontal distance of d = 15.5m before hitting the ground. From what height was the rock thrown? Use the value g ...

Question part a which of the following gives the correct

Question: Part A: Which of the following gives the correct permitted values of ml for l=2? Part B: A second important result is that electrons will fill the lowest energy states available. This would seem to indicate tha ...

Consider the roller coaster below in terms of speedwhere

Consider the roller coaster below in terms of speed. Where will it speed up and where will it slow down? From this consideration, make a sketch of a velocity-time graph for this image. Explain your graph. Post your sketc ...

Fire behavior and combustionwhen pump operators apply

Fire Behavior and Combustion. When pump operators apply pressure to water in pre-connect hose lines there is a limit on the amount of water and velocity at which the water will travel through the hose lines. This is refe ...

Question the siren of a fire engine that is driving

Question: The siren of a fire engine that is driving northward at 31.0 m/s emits a sound of frequency 2020 Hz. A truck in front of this fire engine is moving northward at 19.0 m/s. a) What is the frequency of the siren's ...

Question the potential difference between the surface of a

Question: The potential difference between the surface of a 3.2 cm -diameter power line and a point 1.5 mdistant is 4.7 kV. What is the magnitude of the line charge density on the power line? Express your answer using tw ...

Question a point charge is released from rest in a region

Question: A point charge is released from rest in a region containing an electric field. The charge will start to move: (A) in a direction that makes its potential energy increase (B) in a direction that makes its potent ...

Question in a physics laboratory experiment a coil with 180

Question: In a physics laboratory experiment, a coil with 180 turns enclosing an area of 13.5 cm^2 is rotated during the time interval 5.00Ã-10-2 s from a position in which its plane is perpendicular to Earth's magnetic ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert