A block of mass m 30 kg is attached to a spring of, Ask an Expert

Academics

A block of mass m = 3.0 kg is attached to a spring of constant k = 240 N/m. It can slide along a board tilted at an angle theta = 37° to the horizontal. Initially the block is released from rest when the spring is compressed by x 0 = 30 cm.

(a) Find the speed of the block when the spring is relaxed again.

(b) Find the highest point that the block reaches.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91018613

Have any Question?Write your Review or question?

Related Questions in Physics

Question storm clouds build up large negative charges as

Question: Storm clouds build up large negative charges, as described in the chapter. The charges dwell in charge centers, regions of concentrated charge. Suppose a cloud has -25 C in a 1.0-km-diameter spherical charge ce ...

Question a piano tuner stretches a steel piano wire with a

Question: A piano tuner stretches a steel piano wire with a tension of 765 N. The steel wire has a length of 0.500m and a mass of 3.75g . 1. What is the frequency f1 of the string's fundamental mode of vibration? 2. What ...

Question the starter motor of a car engine draws a current

Question: The starter motor of a car engine draws a current of 170 A from the battery. The copper wire to the motor is 5.80 mm in diameter and 1.2 m long. The starter motor runs for 0.670 s until the car engine starts. A ...

A projectile is launched at an angle of 130deg above the

A projectile is launched at an angle of 13.0° above the horizontal. What is its initial speed if it hits a target that is located a horizontal distance of 155 m from the launch point and 10.5 m below the launch level?

A hunter wishes to cross a river that is 1 km wide and that

A hunter wishes to cross a river that is 1 km wide and that flows with a speed of 3 km/h. The hunter uses a small powerboat that moves at a maximum speed of 11 km/h with respect to the water. What is the time necessary f ...

Question part a what focal length does the lens need assume

Question: Part A: What focal length does the lens need? Assume that it is a thin lens. Part B: How far should you place the lens from the slide? The response must be typed, single spaced, must be in times new roman font ...

Question part a how long in ns does it take light to travel

Question: PART A: How long (in ns) does it take light to travel 0.800m in vaccum? Express your answer in the appropriate units PART B: What distance does light travel in water during the time that it travels 0.800m in va ...

A particle starts from the origin at t 0 with an initial

A particle starts from the origin at t = 0 with an initial velocity having an x component of 26.6 m/s and a y component of -14.8 m/s. The particle moves in the xy plane with an x component of acceleration only, given by ...

Question you are testing a new amusement park roller

Question: You are testing a new amusement park roller coaster with an empty car with a mass of 110KG . One part of the track is a vertical loop with a radius of 12.0 METERS . At the bottom of the loop (point A) the car h ...

Question a point charge with charge q1 is held stationary

Question: A point charge with charge q1 is held stationary at the origin. A second point charge with charge q2moves from the point (x1, 0) to the point (x2, y2). Please use k for Coulomb's constant rather than writing it ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert