Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Calculating the height from which ball is thrown.

A ball is tossed from an upper-story window of a building. The ball is given an initial velocity of 8 m/s at an angle of 20.0? Below the horizontal. It strikes the ground 3 s later. (a) How far horizontally from the base of the building does the ball strike the ground? (b) Find the height from which the ball was thrown. (c) How long does it take the ball to reach a point 10.0 m below level of launching?

Physics, Academics

  • Category:- Physics
  • Reference No.:- M917253

Have any Question? 


Related Questions in Physics

A 162 g mass is hung on a spring as a result the spring

A 162 g mass is hung on a spring. As a result the spring stretches 19.5 cm. If the object is then pulled an additional 3.0 cm downward and released, what is the period of the resulting oscillation? Give your answer in se ...

An accelerating sports car goes from 0 mph to 60 mph in

An accelerating sports car goes from 0 mph to 60 mph in five seconds. Its velocity is given in the following table, converted from miles per hour to feet per second, so that all time measurements are in seconds. (Note: 1 ...

1 a pressure of 10 mpa is applied to 025 m3nbspof a liquid

1. A pressure of 10 MPa is applied to 0.25 m 3  of a liquid, causing a volume reduction of 0.005 m 3 . Determine the bulk modulus of elasticity. 2. The bulk modulus of elasticity for water is 2.205 GPa. Determine the cha ...

A huge essentially infinite horizontal nonconducting sheet

A huge (essentially infinite) horizontal nonconducting sheet 10.0 cm thick has charge uniformly spread over both faces. The upper face carries+95.0 nC/m 2 while the lower face carries -25.0 nC/ m 2 . What is the magnitud ...

Estimate how many patterns in ay are recognizable as the

Estimate how many patterns in AY are recognizable as the character ‘2'. [The aim of this problem is to try to demonstrate the existence of as many patterns as possible that are recognizable as 2s.] Discuss how one might ...

In a conventional thyristor 12-pulse converter estimate the

In a conventional thyristor 12-pulse converter, estimate the internal drop of voltage, regulation, and PF for the following data set. Source Load V = 220 V   F = 60 Hz α = 20° L = 0.1 mH R load = 20 Ω R = 0.1 Ω L load = ...

The purpose of this problem is to show in three ways that

The purpose of this problem is to show in three ways that the binding energy of the electron in a hydrogen atom is negligible compared with the masses of the proton and electron. (a) Calculate the mass equivalent in u of ...

Compare the expected message length when an ascii file is

Compare the expected message length when an ASCII file is compressed by the following three methods. Huffman-with-header. Read the whole file, find the empirical frequency of each symbol, construct a Huffman code for tho ...

1 in the 1980s the term picowave was used to describe food

1. In the 1980s, the term picowave was used to describe food irradiation in order to overcome public resistance by playing on the well-known safety of microwave radiation. Find the energy in MeV of a photon having a wave ...

1 implement the covariant ica algorithm and apply it to toy

1. Implement the covariant ICA algorithm and apply it to toy data. 2. Create algorithms appropriate for the situations: (a) x includes substantial Gaussian noise; (b) more measurements than latent variables (J > I); (c) ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen