A 2.10g bullet embeds itself in a 1.60kg block, which is, Ask an Expert

Academics

A 2.10g bullet embeds itself in a 1.60kg block, which is attached to a spring of force constant 770 N/m.

1)If the maximum compression of the spring is 5.50 cm, find the initial speed of the bullet.

2)Find the time for the bullet-block system to come to rest.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9689766

Have any Question?Write your Review or question?

Related Questions in Physics

Question a particle leaves the origin with an initial

Question: A particle leaves the origin with an initial velocity v = (3.00 i hat) m/s and a constant acceleration a = (-3.00 i hat - 1.400 j hat) m/s2 (a) What is the velocity of the particle when it reaches its maximum x ...

Question the passengers in a roller coaster car feel 50

Question: The passengers in a roller coaster car feel 50% heavier than their true weight as the car goes through a dip with a 30 m radius of curvature. What is the car's speed at the bottom of the dip? The response must ...

Question a rocket is launched straight up with constant

Question: A rocket is launched straight up with constant acceleration. Four seconds after liftoff, a bolt falls off the side of the rocket. The bolt hits the ground 6.30s later. What was the rocket's acceleration in m/s^ ...

Question at one point in a pipeline the waters speed is 300

Question: At one point in a pipeline the water's speed is 3.00 m/s and the gauge pressure is 5.00 x 10 4 Pa. Find the gauge pressure at a second point in the line, 11.0 m lower than the first, if the pipe diameter at the ...

Question a proton and an alpha particle are momentarily at

Question: A proton and an alpha particle are momentarily at rest at a distance r from each other. They then begin to move apart. Find the speed of the proton by the time the distance between the proton and the alpha part ...

Can you please explain how to get an answer for this

Can you please explain how to get an answer for this question and what formula to use step by step and why. "In a race you first ride a bicycle at an anverage speed of 18.4 mi/h for 19.5 miles, then you must run for anot ...

Question in this problem you will estimate the heat lost by

Question: In this problem you will estimate the heat lost by a typical house, assuming that the temperature inside is Tin=20^C and the temperature outside is Tout=0^C. The walls and uppermost ceiling of a typical house a ...

Question the position of a particle moving along an x axis

Question: The position of a particle moving along an x axis is given by x = 14.0t2 - 3.00t3, where x is in meters and t is in seconds. Determine (a) the position, (b) the velocity, and (c) the acceleration of the particl ...

Question a point charge of magnitude q is at the center of

question: A point charge of magnitude q is at the center of a cube with sides of length L. Part A: What is the electric flux ? through each of the six faces of the cube? Use 0 for the permittivity of free space. and Part ...

Question starting from rest a computer disk drive is turned

Question: Starting from rest, a computer disk drive is turned on and has constant angular acceleration. If it takes 0.9s for the drive to make it's second complete revolution, find the following: a) How long did it take ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert