2surface crystallography and epitaxyltbrgtltbrgtfe thin, Ask an Expert

Academics

2. Surface Crystallography and Epitaxy

Fe thin films are grown on a single-crystal Al (100) substrate surface. The films grow with no dislocations (if they are thin enough) which suggests that the atoms find a way to line up nicely across the Al/Fe interface. Fe is bcc with a lattice parameter of 2.867Å and Aluminum is fcc with a lattice constant of 4.050Å. Describe the crystalline orientation of the Fe on the Al (100) surface. (Either draw a picture or tell me which Fe surface is parallel to the Al (100) surface and what direction in the Fe is parallel to what direction in the Al. (This problem is rigged to make it very easy. Look at the ratio of the lattice constants and see if it is a familiar number.)

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M9515167

Have any Question?Write your Review or question?

Related Questions in Physics

A projectile is fired at ground level with an initial

A projectile is fired at ground level with an initial speed of 36 m/s, at an angle of 34 degrees above the horizontal. It hits a target above the ground 2.4 seconds later. What is the horizontal distance in meters, from ...

A ball with a mass of 15 kg is observed to move with an

A ball with a mass of 1.5 kg is observed to move with an acceleration of 6 m/s2. What is the size of the net force acting on the ball? A 2.5-kg block being pulled across a table by a horizontal force of 80 N also experie ...

Question a projectile is fired with speed v0 at an angle

Question: A projectile is fired with speed v0 at an angle Î¸ from the horizontal as shown in the figure (Figure 1) . Part A Find the highest point in the trajectory, H. Part B: What is the range of the projectile, R? Par ...

Question an old-fashioned lp record rotates at 33 13 rpm

Question: An old-fashioned LP record rotates at 33 1/3 rpm (revolutions per minute) and is 12 inches in diameter. A "single" rotates at 45 rpm and is 7.0 inches in diameter. If a fly sits on the edge of an LP and then on ...

Question the position of a mass oscillating on a spring is

Question: The position of a mass oscillating on a spring is given byx = (6.8 cm) cos[2t/(0.91 s)]. (a) What is the frequency of this motion? (b) When is the mass first at the position x =-6.8cm? The response must be type ...

Question a stretched spring stores 22 of energy how much

Question: A stretched spring stores 2.2 of energy. How much energy will be stored if the spring is stretched three times as far? The response must be typed, single spaced, must be in times new roman font (size 12) and mu ...

Question resistivity measurements on the leaves of corn

Question: Resistivity measurements on the leaves of corn plants are a good way to assess stress and overall health. The leaf of a corn plant has a resistance of 2.3 MÎ© measured between two electrodes placed 20 cm apart ...

Swimming at 150 ms relative to still water a swimmer heads

Swimming at 1.50 m/s relative to still water, a swimmer heads directly across a river of width 80 m. He arrives 45.0 m downstream from the point directly across the river from his starting point. (a) What is the speed o ...

Question part a at what angle icirccedil1 to the normal

Question: Part A: At what angle Î¸1 to the normal would the first dark ring be observed? Part B: Suppose that the light from the pinhole projects onto a screen 3 meters away. What is the radius of the first dark ring on ...

An ideal gas of molecules of mass 33 x 10 -27kg is at

An ideal gas of molecules (of mass 3.3 x 10 -27kg) is at temperature 400 K and density 0.1 kg/m3. The gas is confined within a cube of side length 2 m. What is magnitude of the average force experienced by one of the wal ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert