Ask Physics Expert

1) Evaluate the work done W= Int (from O to P) F  dr = Int (from O to P) (Fx dx + Fy dy) by the two-dimensional force F = (x2, 2x, y) along the three paths joining the origin to the point P = (1, 1) and defined as follows: (a) This path goes along the x axis to Q = (1,0) and then straight up to P. (Divide the integral into two pieces, Int (from O to P) = Int (from O to Q) + Int (from P to Q). (b) On this path y = x2, and you can replace the term dy in W by dy = 2xdx and convert the whole integral into an integral over x. (c) This path is given parametrically as x = t3, y = t2. In this case rewrite x, y, dx and dy in W and convert the integral into an integral over t.

1853_curve.png

2) A particle of mass m is moving on a frictionless horizontal table and is attached to a massless string, whose other end passes through a hole in the table, where I am holding it. Initially the particle is moving in a circle of radius ro with angular velocity wo, but I now pull the string down through the hole until a length r remains between the hole and the particle. (b) Assuming that I pull the string so slowly that we can approximate the particle's path by a circle of slowly shrinking radius, calculate the work I did pulling the string. (b) Compare your answer to part a with the particle's gain in kinetic energy.

3) (a) Consider a mass m in a uniform gravitational field g, so that the force on m is mg, where g is a show that the work done by gravity is Wgrav(1 τ 2) = -mgh where h is the vertical height gained between points 1 and 2. Use this result to prove that the force of gravity is conservative (at least in a region small enough so that g can be considered constant).

(b) Show that, if we choose axes with y measured vertically up, the gravitational potential energy is U = mgy (if we choose U = 0 at the origin).

4) For a system of N particles subject to a uniform gravitational field g acting vertically down, prove that the total gravitational energy is the same as if all the mass were concentrated at the CM of the system, that is: U = Summation (alpha on bottom of summation) Ualpha = MgY, where M = summation of Malpha is the total mass and R = (X, Y, Z) is the position of the CM, with the y coordinate measured vertically up.

5) Consider a small frictionless puck perched at the top of a fixed sphere of radius R. If the pluck is given a tiny nudge so that it begins to slide down, through what vertical height will it descend before it leaves the surface of the sphere? [Hint: Use conservation of energy and Newton's second law.]

6) (a) The force exerted by a one-dimensional spring, fixed at one end, is F = -kx, where x is the displacement of the other end from its equilibrium position. Assuming that this force is conservative (which it is) show that the corresponding potential energy is U = (1/2) kx2, if we choose U to be zero at the equilibrium position.

(b) Suppose that this spring is vertically hung from the ceiling with a mass m suspended from the other end and constrained to move in the vertical direction only. Find the extension xo of the new equilibrium position with the suspended mass. Show that the total potential energy (spring plus gravity) has the same form (1/2) ky2 if we use coordinate y equal to the displacement measured from the new equilibrium position at x = xo (and redefine our reference point so that U = 0 at y = 0).

Physics, Academics

  • Category:- Physics
  • Reference No.:- M91628197
  • Price:- $50

Priced at Now at $50, Verified Solution

Have any Question?


Related Questions in Physics

Question oppositely charged parallel plates are separated

Question: Oppositely charged parallel plates are separated by 5.31 mm. A potential difference of 600 V exists between the plates. (a) What is the magnitude of the electric field between the plates? N/C (b) What is the ma ...

Question an object of mass m attached to a spring of force

Question: An object of mass m attached to a spring of force constant k oscillates with simple harmonic motion. The maximum displacement from equilibrium is A and the total mechanical energy of the system is E. What is th ...

Quesion when a nucleus of 235u undergoes fission it breaks

Quesion: When a nucleus of 235U undergoes fission, it breaks into two smaller, more tightly bound fragments. Part A: Calculate the binding energy per nucleon for 235U. Express your answer with the appropriate units. E=__ ...

Question a nylon rope used by mountaineers elongates 130 m

Question: A nylon rope used by mountaineers elongates 1.30 m under the weight of a 65.0-kg climber. If the rope is 45.0 m in length and 7.0 mm in diameter, what is Young's modulus for this material? The response must be ...

Question an object is 30 cm in front of a converging lens

Question: An object is 30 cm in front of a converging lens with a focal length of 10 cm. Use ray tracing to determine the location of the image. What are the image characteristics: (i) upright or inverted, (ii) magnifica ...

Question an object of mass m is traveling on a horizontal

Question: An object of mass m is traveling on a horizontal surface. There is a coefficient of kinetic friction µ between the object and the surface. The object has speed v when it reaches x=0 and encounters a spring. Th ...

Question in one of the classic nuclear physics experiments

Question: In one of the classic nuclear physics experiments at the beginning of the 20th century, an alpha particle was accelerated towards a gold nucleus and its path was substantially deflected by the Coulomb interacti ...

Question an object of mass m is dropped from height h above

Question: An object of mass m is dropped from height h above a planet of mass M and radius R. Find an expression for the object's speed as it hits the ground. Express your answer in terms of the variables m,M,h,R and app ...

Question one type of bb gun uses a spring-driven plunger to

Question: One type of BB gun uses a spring-driven plunger to blow the BB from its barrel. (a) Calculate the force constant of its plunger's spring if you must compress it 0.130 m to drive the 0.0580-kg plunger to a top s ...

Question an object is placed 30 cm to the left of a

Question: An object is placed 30 cm to the left of a converging lens that has a focal length of 15cm. Describe what the resulting image look like (i.e. image distance, magnification, upright or inverted images, real or v ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As