Ask Physics Expert

1. The speed of sound waves in water (density 1.00 x 10 3 kg/m 3 ) is c=1480 m/s.

(a) What is the average intensity (in W/m 2 ) of a 1000 Hz sound wave in water if the displacement amplitude of the wave is 1.00 nm? (1 nm=10 -9 m).

(b) What is the ratio of pressure amplitude to displacement amplitude in this wave?

(c) Assuming an absorption coefficient of 0.0001 dB/m in the water, how far does a plane wave have to travel in the water so that its displacement amplitude is reduced from 1.0nm to 0.1 nm?

2. Two isotropic acoustic sources are located a distance of 10.0 m apart along an x-axis. The source at x=0 puts out a total acoustic power of 1.00 mW, while the source at x=10 m puts out a total power of 2.00 mW. Assuming that the acoustic intensity at any x between the sources is just the sum of the intensities arriving from the two sources,

(a) at what value of x between the sources is the acoustic intensity a minimum (ignore any effects due to absorption in the surrounding air)?

(b) What is the minimum intensity between the sources, and what is the corresponding intensity level in dB?

3. A string of mass per unit length ??is joined to a string of mass per unit length 1.5μ at x=0 in such a way that the tensions in the two strings are different. (This can be done by using a mass less, frictionless slip ring as illustrated in Figure 5.4 in M10-5, p. 97.) The lighter string is under twice the tension of the heavier string. If a transverse wave pulse of amplitude A is incident in the lighter string,

(i) What are the amplitudes of the pulses reflected and transmitted at the junction between the two strings?

(ii) What fraction of the incident energy is transmitted?

4.(a) The frequency of the note referred to as "middle C" on the piano is approximately 256!Hz. Suppose the string that oscillates at 256 Hz in its fundamental mode is 1.00 m long and has mass per unit length 2.00 g/cm. What tension must be applied to this string to produce the desired frequency?

(b) The lowest note on the piano corresponds to a frequency of 32 Hz. Assuming that the tension applied to this string is the same as that found for "middle C" in part (a), and that the string must have length 2.00 m, what is the required mass per unit length?

5. Two isotropic point sources of sound are locate distances of 5.00 m and 3.00 m away from a point P in a lossless (i.e., non-absorbing) medium in which the sound speed is 340!m/s. The sources operate at identical frequencies of 1000 Hz, and the power emitted by each source is equal to 5.27 mW. The waves from the two sources are traveling in very nearly the same direction when they reach P.

(a) The phases of the simple harmonic vibrations of the sources are in phase with each other.
Assuming coherent superposition, find the resultant acoustic intensity and the intensity level at point P. (Remember that the amplitudes at P are not identical.)

(b) The phase of the more distant source (the one 5.00 m away from P) is now slowly increased until an interference maximum (i.e., constructive interference) is achieved at P.

By how many radians has the phase been increased when constructive interference is first achieved? (Increasing the phase of a source causes a given feature, such as a wave crest, to be emitted earlier in time.) Also find the value of the intensity at P under the new
circumstances.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M91631241
  • Price:- $30

Priced at Now at $30, Verified Solution

Have any Question?


Related Questions in Physics

Question oppositely charged parallel plates are separated

Question: Oppositely charged parallel plates are separated by 5.31 mm. A potential difference of 600 V exists between the plates. (a) What is the magnitude of the electric field between the plates? N/C (b) What is the ma ...

Question an object of mass m attached to a spring of force

Question: An object of mass m attached to a spring of force constant k oscillates with simple harmonic motion. The maximum displacement from equilibrium is A and the total mechanical energy of the system is E. What is th ...

Quesion when a nucleus of 235u undergoes fission it breaks

Quesion: When a nucleus of 235U undergoes fission, it breaks into two smaller, more tightly bound fragments. Part A: Calculate the binding energy per nucleon for 235U. Express your answer with the appropriate units. E=__ ...

Question a nylon rope used by mountaineers elongates 130 m

Question: A nylon rope used by mountaineers elongates 1.30 m under the weight of a 65.0-kg climber. If the rope is 45.0 m in length and 7.0 mm in diameter, what is Young's modulus for this material? The response must be ...

Question an object is 30 cm in front of a converging lens

Question: An object is 30 cm in front of a converging lens with a focal length of 10 cm. Use ray tracing to determine the location of the image. What are the image characteristics: (i) upright or inverted, (ii) magnifica ...

Question an object of mass m is traveling on a horizontal

Question: An object of mass m is traveling on a horizontal surface. There is a coefficient of kinetic friction µ between the object and the surface. The object has speed v when it reaches x=0 and encounters a spring. Th ...

Question in one of the classic nuclear physics experiments

Question: In one of the classic nuclear physics experiments at the beginning of the 20th century, an alpha particle was accelerated towards a gold nucleus and its path was substantially deflected by the Coulomb interacti ...

Question an object of mass m is dropped from height h above

Question: An object of mass m is dropped from height h above a planet of mass M and radius R. Find an expression for the object's speed as it hits the ground. Express your answer in terms of the variables m,M,h,R and app ...

Question one type of bb gun uses a spring-driven plunger to

Question: One type of BB gun uses a spring-driven plunger to blow the BB from its barrel. (a) Calculate the force constant of its plunger's spring if you must compress it 0.130 m to drive the 0.0580-kg plunger to a top s ...

Question an object is placed 30 cm to the left of a

Question: An object is placed 30 cm to the left of a converging lens that has a focal length of 15cm. Describe what the resulting image look like (i.e. image distance, magnification, upright or inverted images, real or v ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As