Sketch or draw the two-view drawing shown in Figure 18.45. Add the geometric dimensioning information per the following information:
a. Where the small cylinder intersects the large cylinder in the right side view, make the face on the larger cylinder datum feature D. Control this surface with a flatness tolerance of .005.
b. In the right side view, make the axis of the small cylinder datum feature E. The axis must be perpendicular within a .002 cylindrical tolerance zone at maximum material condition relative to datum feature D.
c. In the front view, make the .500-.505 slot datum feature F. Position this slot within a .003 tolerance zone at maximum material condition relative to primary datum feature D and secondary datum feature E at maximum material condition.
d. Make the 2.500 and 4.00 diameters basic dimensions.
e. Position the four small holes within a .005 cylindrical tolerance zone at maximum material condition relative to primary datum feature D, secondary datum feature E at maximum material condition, and tertiary datum feature F at maximum material condition.
f. Apply a profile of a surface tolerance of .050 to the outside surface in the front view relative to primary datum feature D and secondary datum feature E at maximum material condition.
