Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Other Engineering Expert

Question:

Design a tri-gneration system on ASPEN HYSYS.

This system can generate - electricity, heating and cooling.

All data and the drawing on the trigeneration system are attached, However i need someone to do the calculations and analysis on my aberdeen and send me all the data which was put in and all results in a table format.

Design an energy system with the following components:

An internal reforming Solid Oxide Fuel Cell (SOFC) engine

An organic Rankine cycle (ORC)

Unfired heat recovery steam generator (HRSG) to the ORC condenser

A single effect absorption chiller cycle

I can draw all of these but i simply need the calculations and all the numbers put in on ASPEN and results out.

The following questions have to be answered for assignment and all equations used to find the answers have to be shown

1. Power output from fuel cell and engine efficiency

2. Power output from Organic Rankine Cycle and efficiency

3. Power output from absorption chiller cycle and efficiency

4. Total power output from the energy system

5. A document explaining everything which has been done (DATA INPUTTED AT EACH STAGE AND RESULTS) on aspen hysys including figures, tables and equations.

It would be helpful if an initial design is made first and then this can later be optimized. But it's important for me to see the initial design ASAP. I might be able to do the optimization myself.

If any types of analysis such as energy/exergy analysis, pinch analysis and also environmental analysis of the results can be carried out, this would be highly appreciated. But if it cannot be done, that's fine too.

I have attached a file with some data In addition I have attached,

1. A schematic diagram of the whole energy system

2. A closer look at the ORC to help input into ASPEN HYSYS (ideal regenerative rankine cycle)

3. A closer look at Absorption Chiller Cycle to help input into ASPEN HYSYS can be found here http://www.energy-2030.com/08/pdfs/r-t9-6.pdf.pdf. However, here they have absorber and evaporator have been modelled as heaters. These must be modelled as coolers as we are generating cooling from this cycle.

4. A generic model of a fuel cell on Aspen HYSYS. This does not any of my data inputted and has to be edited.

Articles:

1. Performance evaluation of an SOFC based trigeneration system using various gaseous fuels from biomass gasification by Hasan Ozcan and Ibrahim Dincer

2. Modelling and Simulation of Trigeneration Systems Integrated with Gas Engines by M. C. Ekwonu, S. Perry, E. A. Oyedoh

3. Biomass fuelled trigeneration system in selected buildings Y. Huang a, Y.D. Wang b, S. Rezvani, D.R. McIlveen-Wright, M. Anderson, N.J. Hewitt

4. A hybrid optimization model of biomass trigeneration system combined with pit thermal energy storage D.F. Dominkovic, B.Cosic, Z.Bacelic Medic, N. Duic

Attachment:- Data.rar

Other Engineering, Engineering

  • Category:- Other Engineering
  • Reference No.:- M91695210
  • Price:- $150

Guranteed 48 Hours Delivery, In Price:- $150

Have any Question?


Related Questions in Other Engineering

Engineering analysis homework -for every problem provide

Engineering Analysis Homework - For every problem, provide The MATLAB script/function files that solve the problems. Problem 1: Write a script that solves the problem. For (c), show results of the evaluation of every ind ...

Projection of planes1 a regular pentagon of 25 mm side has

Projection of Planes 1. A regular pentagon of 25 mm side has one side on the ground. Its plane is inclined at 45° to H.P. and perpendicular to the V.P. Draw its projections. 2. Draw the projection of a circle of 50 mm di ...

Load fault level analysis amp protection design of a remote

LOAD, FAULT LEVEL ANALYSIS & PROTECTION DESIGN OF A REMOTE AREA MICROGRID Assignment Please undertake the following analyses: 1. Calculate the 3-phase fault levels on Bus 2, Bus 3 and Bus 4 with the main supply connected ...

Task 1using the lab kit design a circuit for the processor

Task 1: Using the lab kit, design a circuit for the processor to control the output of a connected 7-segment LED display device. You will be provided with a standard common anode 7-segment display of the type FND-507 (or ...

A detailed review of spatial modulation and simulation

A Detailed Review of Spatial Modulation and Simulation Learning Outcomes a. Learn how to model mobile communication channels d. Discern knowledge development and directions on the recent advances in 4G to the research pr ...

Q 1a discontinuity is found fully developed from the toe to

Q. 1 A discontinuity is found fully developed from the toe to the bench surface on a 15 m high slope, slope angle 65°. The discontinuity (frictional angle 32° and cohesion 20 kN/m2) is planar and its strike is parallel t ...

This is your second design assignment this assignment

This is your second design assignment. This assignment requires you to design a complex state machine. You are designing a digital alarm clock. There are various designs you can attempt. More complex designs are worth mo ...

Assessment practical reportproduce a short technical report

Assessment: Practical Report Produce a short technical report in a form consistent with proteomic journals covering the techniques, results and interpretation of your proteomics experiment in the practical classes. The r ...

Operations engineering assignment -please select only one

Operations Engineering Assignment - Please select only one of the following case studies for your assignment: CASE A. Tesla Motors Tesla is an innovative manufacturer that designs, assemble and sells fully electric vehic ...

Assignment 11 what is the purpose of ore reserve and

ASSIGNMENT 1 1. What is the purpose of ore reserve and resource estimation? Why are resource and reserve estimates important to the mining industry? 2. What is meant by ore? What is meant by the term waste? How is the di ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As